"RF680M" software9.6 The functions in the "Extras" menuSIMATIC RF680M Mobile Reader76 Operating Instructions, 06/2011, J31069-D0241-U001-A2-7618Figure 9-18 Settings windowSettings in "Scan mode"Here, you can choose between single tag and bulk scanning.● With "Single Tag", the tags are only scanned until a tag ID is detected.● With "Bulk", the device will constantly try to scan additional tag IDs (until time-out ormanual interruption of the command).This setting is appropriate, for example, if you are searching for a specific tag in a fieldthat contains several tags.Settings under "Format"You can set different formats (for the editor, data, address and length) under "Format" thatare explained below.● Effect of the "Editor" settings:Byte, binaryDepending on the format that you select, the interface in the data editor is as depictedbelow:
