Siemens SIMATIC NET SCALANCE S615 Configuration Manual

Also see for SIMATIC NET SCALANCE S615: Operating instructions Configuration manual Operating instructions

Upkeep and maintenance 55.1 Device configuration with PRESET-PLUGPlease not the additional information and security notes in the operating instructions of yourdevice.NOTICEDo not remove or insert a PLUG during operationA PLUG may only be removed or inserted when the device is turned off.NoteSupport as of V4.3The PRESET-PLUG functionality is supported as of firmware version V4.3.With the PRESET-PLUG, you can install the same device configuration (start configuration,user accounts, certificates) including the corresponding firmware on multiple devices.The PRESET PLUG is write-protected.You configure the PRESET PLUG using the Command Line Interface (CLI).Creating a PRESET-PLUGYou create the PRESET PLUG using the Command Line Interface (CLI). You can create aPRESET-PLUG from any PLUG. To do this, follow the steps outlined below:NoteUsing configurations with DHCPCreate a PRESET-PLUG only from device configurations that use DHCP. Otherwisedisruptions will occur in network operation due to multiple identical IP addresses.You assign fixed IP addresses extra following the basic installation.Requirement● A PLUG is inserted in the device on which you want to configure the PRESET-PLUGfunctionality.Procedure1. Start the remote configuration using CLI and log on as a user with the "admin" role.The CLI connection works either with Telnet (port 23) or SSH (port 22).2. Switch to the global configuration mode with the command "configure terminal".3. You change to the PLUG configuration mode with the "plug" command.SCALANCE S615 Web Based ManagementConfiguration Manual, 11/2019, C79000-G8976-C388-08 297