Siemens SIMATIC NET SCALANCE S615 Configuration Manual

Also see for SIMATIC NET SCALANCE S615: Operating instructions Operating instructions Configuration manual

Contents

Configuring with Web Based Management4.4 "System" menuSCALANCE S615 Web Based ManagementConfiguration Manual, 05/2015, C79000-G8976-C388-02 77Table 2 has the following columns:● EventThe "Event" column contains the following:– Cold/Warm StartThe device was turned on or restarted by the user.– Link ChangeThis event occurs only when the port status is monitored and has changed, see"System > Fault Monitoring > Link Change".– Authentication FailureThis event occurs when attempting access with a bad password.– Fault State ChangeThe fault status has changed. The fault status can relate to the activated portmonitoring, the response of the signaling contact or the power supply monitoring.– IPSec VPN LogsAn entry is made in the security log if the IPsec method for VPN was used.– Firewall LogsEach time individual firewall rules are applied, this is recorded in the firewall log. To dothis, the LOG function must be enabled for the various firewall functions.– DDNS Client LogsThe event occurs when the DDNS client synchronizes the assigned IP address withthe hostname registered at the DDNS provider.– System Connection StatusThe connection status has changed.– System General LogsConnection establishment, change to the configuration.– Digital InThe event occurs when the status of the digital input has changed.– VPN-TunnelThe event occurs when the status of VPN (IPsec, OpenVPN, SRC) has changed.E-MailThe device sends an e-mail. This is only possible if the SMTP server is set up and the"SMTP client" function is enabled.● TrapThe device sends an SNMP trap. This is only possible if "System > Configuration"SNMPv1 Traps" is enabled.● Log TableThe device writes an entry in the event log table, see "Information > Log Table"