Siemens SIMATIC NET SCALANCE S615 Configuration Manual

Also see for SIMATIC NET SCALANCE S615: Operating instructions Operating instructions Configuration manual

Contents

Configuring with Web Based Management4.4 "System" menuSCALANCE S615 Web Based Management112 Configuration Manual, 05/2015, C79000-G8976-C388-02DescriptionThe page contains the following boxes:● "DHCP Client Config File Request (Opt.66, 67)" check boxSelect this option if you want the DHCP client to use options 66 and 67 to download andthen enable a configuration file.● "DHCP Mode" drop-down listSelect the DHCP mode from the drop-down list. The following modes are possible:– via MAC AddressIdentification is based on the MAC address.– via DHCP Client IDIdentification is based on a freely defined DHCP client ID.– via System NameIdentification is based on the system name. If the system name is 255 characters long,the last character is not used for identification.The table has the following columns:● InterfaceInterface to which the setting relates.● DHCPEnable or disable the DHCP client for the relevant interface.ProcedureFollow the steps below to configure the IP address using the DHCP client ID:1. Enable the "DHCP Client" option.2. Select the DHCP mode "via DHCP Client ID" from the "DHCP Mode" drop-down list.3. Enter a character string to identify the device in the enabled "DHCP Client ID" input box.This is then evaluated by the DHCP server.4. Select the "Client Config File Request (Opt.66, 67)" option, if you want the DHCP client touse options 66 and 67 to download and then enable a configuration file.5. Click the "Set Values" button.NoteIf a configuration file is downloaded, this triggers a system restart. Make sure that theoption "Client Config File Request (Opt.66, 67)" is no longer set in this configuration file.