Siemens SIMATIC HMI series Operating Instructions Manual

Also see for SIMATIC HMI series: Installation instructions Operating instructions Operating instructions System manual Operating instructions

Contents

Installing and connecting the device3.1 Preparing for installationIFP, IFP PRO, IFP ETHOperating Instructions, 11/2017, A5E31298376-AH 413.1.2.3 Preparing the mounting cutoutNoteStability of the mounting cutoutThe material in the area of the mounting cutout must be sturdy enough to ensure permanentsafe mounting of the device.To achieve the degrees of protection described below, it must be ensured that deformationof the material cannot occur due to the force of the mounting clips or operation of the device.Degrees of protectionThe various degrees of protection of the device can only be guaranteed if the followingrequirements are met:● To achieve the degree of protection specified in the technical specifications: Materialthickness at the mounting cut-out: 2 mm to 6 mm● Permitted deviation from plane at the mounting cutout: ≤ 0.5 mmThis condition must also be met for the installed device.● Permissible surface roughness in the area of the seal: ≤ 120 μm (Rz 120)Dimensions of the mounting cutoutWidth and height should be reversed accordingly when mounting in vertical format.