Siemens RUGGEDCOM RX5000 Installation Manual

Also see for RUGGEDCOM RX5000: Reference guide Installation guide

RUGGEDCOM RX5000Installation GuideChapter 2Installing the DeviceInstalling/Removing Power Supplies 9• For 125/250 VDC rated equipment, an appropriately rated DC circuit breaker must be installed.• It is recommended to provide a separate circuit breaker for each power supply module.• Equipment must be installed according to applicable local wiring codes and standards.The following sections describe how to connect power to the device:• Section 2.2.1, “Installing/Removing Power Supplies”• Section 2.2.2, “Connecting AC Power”• Section 2.2.3, “Connecting DC Power”Section 2.2.1Installing/Removing Power SuppliesThe RX5000 supports dual redundant AC and/or DC power supplies that can be installed in any combination.Slots for the removable power modules are located on the rear panel of the device.1 2Figure 5: Power Module Slots1. Slot PS1 2. Slot PS2DANGER!Electrocution hazard – risk of serious personal injury or death. The device may have two powersupplies equipped, which may be connected to separate power sources. Make sure all power sourcesare isolated before servicing the power supplies.The following sections describe how to install, remove and connect the power supplies:• Section 2.2.1.1, “Installing a Power Supply”• Section 2.2.1.2, “Removing a Power Supply”Section 2.2.1.1Installing a Power SupplyTo install a power supply, do the following: