Siemens RDJ100 Operating Instructions Manual

Also see for RDJ100: Operating and installation instructions Programming instructions Operating instructions Operating and installation instructions Quick guide

A6V101035986_en--_c 2018-06-21 Subject to alteration Siemens Building Technologies / HVAC ProductsOperating instructions RDJ100The RDJ100 is a room thermostat with a 24-hour time program that allows you to set the desired room temperature (setpoint)for the desired time. The unit features an ergonomic setting knob for easy temperature control.DisplayActual room temperature in ºC Indicates when heating isdemandedThe unit controls to the selectedcomfort temperature Replace batteriesThe unit controls to the selectedenergy saving temperatureFrost protection: The unit controlscontinuously to frost protectiontemperatureThe unit controls to the selected frostprotection temperatureEnergy saving mode: The unitcontrols continuously to energysaving temperatureIndicates when the temperaturesetpoint was changed by the user.This setpoint will be maintained untilthe next switching time. This functionis only active in automatic mode andcomfort mode.Comfort mode: The unit controlscontinuously to comfort temperatureAutomatic mode: The unit controlsto the selected time andtemperature programsSetting knobWarmer/colder for selectingthe temperature setpointProgramming selectorBattery compartment2 alkaline batteries type AA, 1.5 V Time setting positionOperating mode selector A1 First switch-on timeAutomatic mode: The unit controls to the selected time andtemperature programs A2 First switch-off timeComfort mode: The unit controls continuously to comforttemperature A3 Second switch-on timeEnergy saving mode: The unit controls continuouslyto energy saving temperature A4 Second switch-off timeFrost protection: The unit controls continuously tofrost protection temperature. This setpoint is fixed at 5 ºC Comfort temperature settingAdvance button Energy saving temperature settingSwitches the operating mode from comfort to energy saving,or vice versa, until the next switching time in automatic mode RUN Set the controller to RUN afterprogramming is completedCommissioning∑ Remove the black transit tabsfrom the alkaline batteries.Check to see if the batterycompartment is in its correctposition∑ If no batteries are inserted, fit2 alkaline batteries type AA inthe battery compartmentSetting the time1. Set the programming selector toposition .2. Turn the setting knob to adjustthe time.3. When the correct time isdisplayed, move theprogramming selector to anyother position to confirm yoursettingDEENFRITNLESPTCSHUPLSVFIZHTRELRODA

/ 3

Related manuals for Siemens RDJ100