Siemens Operator Display Panel II Installation Instructions Manual

Contents

product description

Installation InstructionsDocument No. 570-111February 18, 2013Operator Display Panel II (ODP II)Item No. 570-111. Rev. AA Page 1 of 4Product DescriptionThese instructions explain how to field install orreplace the BACnet Fume Hood Controller FHC.The Fume Hood Controller Operator Display Panel(ODP) is the interface between the fume hoodoperator and the controller system. The mountingplate is designed for the fume hoods with or withoutexisting cutouts. Designed for wall-mounting (A). A conduit boxis optional. Base plate (B) has screw holes for allcommercially available conduit boxes. Theheight of the screw heads must not exceed 3mm. Device (C) incorporates a plug, an LCD panel,emergency purge and horn silence buttons.Product Number575-820ARequired ToolsFor fume hood with an existing cutout, you need: Medium Phillips-head screwdriverFor fume hood without a cutout, you need: Medium duty electric drill 1-1/2 inch (38 mm) hole saw bitPrerequisitesCable from controller to ODP is in place.Cable from controller to ODP is less then 50 feet(15 m) in length.

/ 4

Related manuals for Siemens Operator Display Panel II