Siemens Micromaster 440 Operating Instructions Manual

Also see for MICROMASTER 440: Getting started guide Operating instructions Getting started guide Operating instructions Operating instructions

Contents

5 System parameters Issue 12/02MICROMASTER 440 Operating Instructions68 6SE6400-5AW00-0BP05.3 Parameter list (short form)Explanatory information on following table:! Default: Factory setting! Level: Access level! DS Inverter status (Drive State), indicates the inverter state in which aparameter can be modified (see P0010).♦ C Commissioning♦ U Run♦ T Ready to run! QC Quick Commissioning♦ Q Parameter can be modified in the Quick Commissioning state.♦ N Parameter cannot be modified in the Quick Commissioning state.AlwaysPar. No. Parametername Default Level DS QCr0000 Drive display - 1 - -P0003 User access level 1 1 CUT NP0004 Parameter filter 0 1 CUT NP0010 Commissioning parameter 0 1 CT NP0014[3] Store mode 0 3 UT NP0199 Equipment system number 0 2 UT NQuick CommissioningPar. No. Parametername Default Level DS QCP0100 Europe / North America 0 1 C QP3900 End of quick commissioning 0 1 C QParameter ResetPar.-No. Parametername Default Level DS QCP0970 Factory reset 0 1 C NTechnological functionsPar.-No. Parametername Default Level DS QCP0500[3] Technological application 0 3 CT QInverter Unit (P0004 = 2)Par. No. Parametername Default Level DS QCr0018 Firmware version - 1 - -r0026[1] CO: Act. DC-link voltage - 2 - -r0039 CO: Energy consumpt. meter [kWh] - 2 - -P0040 Reset energy consumption meter 0 2 CT Nr0037[5] CO: Inverter temperature [∞C] - 3 - -r0070 CO: Act. DC-link voltage - 3 - -r0200 Act. power stack code number - 3 - -P0201 Power stack code number 0 3 C N