Siemens LF259RB51 Installation And Use Instructions And Warnings

Also see for iQ700: Instructions for use Operating instructions Installation instructions Installation guide Operating instructions

Contents

ImportAppliances.comTHE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.18Grease filters:Metal filters are used to trap the greasyelement of the vapours that developduring cooking.The filter mats are made from non-combustible metal.Caution:As the filter becomes more and moresaturated with grease, not only does therisk of catching fire increase, but theefficiency of the extractor hood can alsobe adversely affected.Important:By cleaning the metal grease filters atappropriate intervals, the possibility ofthem catching fire as a result of a build-upof heat such as occurs when deep-fatfrying or roasting is taking place, isreduced.Saturation indicator:When the grease filters are saturatedflashes. If you switch the hood off, thenthe acoustic signal is removed.The grease filters should be cleanedstraight away.Cleaning the metal grease filters: In normal operation (1-2 hours daily)the metal grease filter must becleaned 1x a month. The filters can be cleaned in a dishwasher. It is however possible thatthey become slightly discoloured.The filters must be placed loosely andNOT wedged in the dishwasherImportant: Metal filters that aresaturared with grease should not bewashed together with other dishes. When clearing the filters by hand,soak them in hot soapy water first ofall. Do not use aggressive, acidic orcaustic cleaners. Then brush thefilters clean, rinse them thoroughlyand leave the water to drain off.Removing and installing the metalgrease filters:Attention: the halogen bulbs must beswitched off and must have cooled down.1. Follow the steps shown in the Mfigures.2. Depress the handles on the greasefilters and fold down the grease filters.3. Clean the grease filters.4. Re-install the cleaned grease filters.5. Clearing the display. Press 2x in succession the Opush button. An acoustic signal isissued and the display goesout.Cleaning and careIsolate the extractor hood by pullingout the mains plug or switching off thefuse.Do not clean the extractor hood withabrasive sponges or with cleaning agentswhich contain sand, soda, acid or chlorine. Clean the extractor hood with a hotsoap solution or a mild windowcleaner. Do not scrape off dried-on dirt butwipe off with a damp cloth. When clearing the grease filters,remove grease deposits fromaccessibile parts of the housing. Thisprevents the risk of fire and ensuresthat the extractor hood continuesoperating at maximum efficiency. Note: do not use alcohol (spirit) onplastic surfances, as dull marks mayappear.