Siemens HA724220 Instruction Manual

31Installation and connectionElectrical connectionThe appliance must be connected to the mains by a licensedexpert. The regulations of your electricity supplier must beobserved.Any damage arising from the appliance being connectedincorrectly will invalidate the guarantee.Caution!If the supply cord is damaged, it must be replaced by themanufacturer, its service agent or similarly qualified persons inorder to avoid a hazard.For the installer■ An all-pole isolating switch with a contact gap of at least3 mm must be present in the installation circuit. This is notnecessary if the appliance is connected by a plug that isaccessible to the user.■ Electrical safety: The cooker corresponds to safety class Iand may only be used in conjunction with a safety earthterminal.■ A type H 05 VV-F or equally rated lead must be used toconnect the appliance.Levelling the cookerAlways place the cooker directly on the floor.1. Pull out the plinth drawer and lift it up and out.There are adjustable feet at the front and rear on the inside ofthe plinth.2. Use an Allen key to raise or lower the adjustable feet asnecessary until the cooker is level (picture A).3. Push the plinth drawer back in (picture B).Wall fixingTo prevent the cooker from tipping over, you must fix it to thewall using the enclosed bracket. Please observe the installationinstructions for fixing the oven to the wall.Your new applianceIn this section you will find information on the appliance, theoperating modes and the accessories.General informationThe design depends on the respective appliance model.%$Explanations1 Hob**2 Control panel**3* Cooling fan4 Oven door**5* Plinth drawer*** Optional (available for some appliances)** Details may vary depending on the appliance model.