Siemens 8DA10 Series Installation And Operating Instructions Manual

Also see for 8DA10: Operating instructions

Operation196/214 Revision 11 • INSTALLATION AND OPERATING INSTRUCTIONS • 8DA10 • 861-9601.9Fig. 209: Pushing the control gate to the right positionTo push the control gate from center position to left position:➭ Remove the right-hand plastic split rivet.➭ Insert the screwdriver into the right-hand opening and push the solenoid back.➭ Push the control gate to the left.➭ Pull out the screwdriver.➭ Push the control gate to the left as far as it will go.➭ Reinstall the right-hand plastic split rivet.✔ The right-hand solenoid is released again, blocking further movements.Fig. 210: Pushing the control gate to the left positionTo push the control gate from the right or left position to the center position again:➭ Remove the plastic split rivet (according to the position of the control gate).➭ Push the solenoid back using the screwdriver.➭ Push the control gate to the center position.➭ Pull out the screwdriver.➭ Reinstall the plastic split rivet.✔ The solenoid is released again, blocking further movements.Fig. 211: Pushing the control gate to the center position