Sharp QT-CD180 Operation Manual

Contents

8Recording to a Cassette TapeBefore recording: When recording important selections, make a preliminary test to en-sure that the desired material is properly recorded. SHARP is not liable for damage or loss of your recording arising frommalfunction of this unit. The ALC (Automatic Record Level Control) circuit automatically con-trols the level of the input signal used for recording. The VOLUME control may be adjusted with no effect on the recordedsignal. (Variable Sound Monitor) Metal and CrO 2 tapes cannot be used for recording. Recording from a CD1 Set the FUNCTION switch to CD.2 Load the disc to be recorded.3 Load a blank cassette into the cassette compartment with theside to be recorded facing toward you.4 Press the RECORD button.5 Press the PLAY/PAUSE 0 60 60 60 60 6 button on the CD.To stop recording:Press the STOP/EJECT 7 button.If the STOP or PLAY/PAUSE 0 6 button is pressed while recording,or if the CD comes to its end, the tape deck will not stop.To record a specific track:Press the REVIEW/DOWN 5 or CUE/UP 4 button until the desiredtrack number is displayed, then start recording. Recording from the radio1 Set the FUNCTION switch to FM or AM.2 Tune in to the station to be recorded.3 Load a blank cassette into the cassette compartment with theside to be recorded facing toward you.4 Press the PAUSE 66666 button.5 Press the RECORD button.6 Press the PAUSE 66666 button again.To stop recording:Press the STOP/EJECT 7 button. Erasing a recorded tape1 Set the FUNCTION switch to TAPE.2 Load a tape into the cassette compartment with the side to beerased facing toward you.3 Press the RECORD button.