Setting the Date and Time251. InstallationSetting the Date and Time1 Press these keys:The display will show:Set the date and time by pressing the keys on the operation panel asshown below.ENTRY MODE1 2 34 5 67 8 90Note: The imaging film and printing paper must be loaded before the dateand time can be set.Do not set the date and time if you are using OpenLCR!OpenLCR automatically sets the date and time each time your fax callsOpenLCR and receives rate data. To ensure accurate use of the rate data, donot change the date and time setting yourself. OpenLCR also sets the dateand time for you if you perform the fax transmission test (see page 36).The date and timeappear in the display andare printed at the top ofevery page you fax.FUNCTION 33 key* keyFUNCTION keySTOP keySTART keyall-ux510A.book Page 25 Thursday, September 14, 2000 9:05 AM
