Sharp Carousel R-980J Operation Manual

Also see for Carousel R-990JS: Operation manual

26A42430, SCA/SCNZ R980J/990J(S) O/MAC Line Voltage Single phase 230-240V, 50HzAC Power Required 1.6 kW (Microwave) / 1.6 kW (Convection)Output PowerMicrowave 900 W* (IEC test procedure)Convection Heater 1500 WMicrowave Frequency 2450 MHz**(Class B/Group 2)Outside Dimensions (WxHxD) 627mm x 378mm x 492mm 627mm x 378mm x 487mmDepth with the door open 942mm 949mmTurntable Diameter 390mmCooking Uniformity Turntable systemWeight Approx. 29 kgSERVICE CALL CHECKPlease check the following before calling service:1. Does the display light up? Yes No2. When the door is opened, does the oven lamp come on? Yes No3. Place one cup of water (approx. 250 ml) in a glass measuring cup in the oven and close the door securely.Oven lamp should go off if door is closed properly.Press the INSTANT COOK/START pad once.A. Does the oven lamp come on? Yes NoB. Does the cooling fan work? Yes No(Put your hand over the rear ventilation openings.)C. Does the turntable rotate? Yes No(The turntable can rotate clockwise or counterclockwise. This is quite normal.)D. Does the COOK indicator light up? Yes NoE. After 1 minutes, is the water hot? Yes No4. Remove water from the oven and programme the oven for 5 minutes at convection 180°C.A. Does the CONV and COOK indicators light up? Yes NoB. After 5 minutes, is the inside of the oven hot? Yes NoIf "NO" is the answer to any of the above questions, please check your wall socket and the fuse in your meter box.If both the wall socket and the fuse are functioning properly, CONTACT YOUR NEAREST SERVICECENTRE APPROVED BY SHARP.NOTE:1. If time in the display is counting down rapidly, check Demonstration Mode. (See P. 23 for detail.)2. After manual or automatic cooking using the Grill, Mix or Convection modes, the cooling fan will switch on to cool the oven cavity.To clear it, press the STOP/CLEAR key and the display will return to the time of day, if set. During these modes, the cooling fanwill carry on working after you have pressed the STOP/ CLEAR key. You may feel hot air blowing out of the ventilation openings.SPECIFICATIONSCARE AND CLEANINGDisconnect the power supply cord before cleaning or leave the door open to inactivate the oven.Before cleaning ensure oven cavity is cool.CLEAN THE OVEN AT REGULAR INTERVALS - Keep the oven clean and remove any food deposits, or it could lead todeterioration of the surface. This could adversely affect the life of the appliance and possibly result in a hazardous situation.Exterior: The outside may be cleaned with mild soap and warm water, wipe clean with a damp cloth. Avoid the use of harsh abrasivecleaners.Door: Wipe the door and window on both sides, the door seals and adjacent parts frequently with a damp cloth toremove any spills or spatters. Do not use abrasive cleaner.Touch Control Panel: Wipe the panel with a cloth dampened slightly with water only. Do not scrub or use any sortof chemical cleaners. Avoid the use of excess water.Interior walls: Wipe spatters and spills with a little dish washing liquid on a soft damp cloth. For heavier stains inside the oven cavityonly, use a mild stainless steel cleaner applied with a soft damp cloth. Do not apply to the inside of the door. Wipe clean ensuring allcleaner is removed.After use wipe the waveguide cover in the oven with a soft damp cloth to remove any food splashes. Built-up splashes mayoverheat and begin to smoke or catch fire. Do not remove the waveguide cover.DO NOT USE CAUSTIC CLEANERS, ABRASIVE OR HARSH CLEANSERS OR SCOURING PADS ON YOUR OVEN.NEVER SPRAY OVEN CLEANERS DIRECTLY ONTO ANY PART OF YOUR OVEN.DO NOT USE A STEAM CLEANER. Avoid using excess water. After cleaning the oven, ensure any water is remove with a soft cloth.Note: At regular intervals, heat the oven referring to "Heating without Food" on page 10. Because, the splashed dirtor food oil remained around oven walls may cause the smoke and odour.Turntable/Turntable Support/Racks: Wash with mild soapy water and dry thoroughly.Note: Keep the waveguide cover and accessories clean at all times. If you leave grease or fat in the cavity oraccessories, it may overheat, cause arching, smoke or even catch fire when next using the oven.SPECIAL NOTE for TURNTABLE SUPPORT:After cooking, always clean the turntable support, especially around the rollers. These must be freefrom food splashes and grease. Built-up splashes or grease may overheat and cause arcing, whichmay produce smoke or catch fire.* When tested in accordance with AS/NZS 2895.1.2004** This is the classification of ISM(Industrial, Scientific and Medical) equipment described in the InternationalStandard CISPR11.Model Name R-980J R-990J(S)rollerSCA/SCNZ R980J14-26 04.8.25, 2:21 PM26