Sharp CD-BK147V Operation Manual

Also see for CD-BK147V: Operation manual

E-12CD-BK147V(S)E2.fm01/9/28ENGLISHCD-BK147VBasic Operation- Setting the clock -Setting the clockIn this example, the clock is set for the 24-hour (0:00) display.Note:The "CLOCK" or time will flash at the push of the CLOCK button when the AC powersupply is restored after a power failure or unplugging the unit.Readjust the clock as follows.To readjust the clock:Perform "Setting the clock" from the beginning. If the time display is flashing, step 3(for selecting the 24-hour or 12-hour display) will be skipped.To change the 24-hour or 12-hour display:1 Press the ON/STAND-BY button to turn the power on.2 Press the CLOCK button and within 5 seconds, press the MEMO-RY/SET button.3 Press the TUNING/TIME ( or ) button to select 24-hour or 12-hour display and then press the MEMORY/SET button."0:00" The 24-hour display will appear.(0:00 - 23:59)"AM 12:00" The 12-hour display will appear.(AM 12:00 - PM 11:59)"AM 0:00" The 12-hour display will appear.(AM 0:00 - PM 11:59)Note that this can only be set when the unit is first installed or it has been reset.[Refer to "Clearing all the memory (reset)" on page 34 for details.]4 Press the TUNING/TIME ( or ) button to adjust the hour and thenpress the MEMORY/SET button.z Press the TUNING/TIME ( or ) button once to advance the time by 1 hour.Hold it down to advance continuously.z When the 12-hour display is selected, "AM" will change automatically to "PM".5 Press the TUNING/TIME ( or ) button to adjust the minutes andthen press the MEMORY/SET button.z Press the TUNING/TIME ( or ) button once to advance the time by 1minute. Hold it down to change the time in 5-minute intervals.z The hour will not advance even if minutes advance from "59" to "00".z The clock begins counting from "0" seconds. (Seconds are not displayed.)The time display will disappear after a few seconds.To confirm the time display:Press the CLOCK button.The time display will appear for about 5 seconds.1 Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" onpage 34 for details.]2 Perform "Setting the clock" from the beginning.Downloaded from: http://www.usersmanualguide.com/