Sharp CD-BA250H Operation Manual

Also see for CD-BA250H: Operation manual Quick guide Service manual Service manual Operation manual

Contents

CD-BA250H/CD-BA2600H– 6 –OPERATION MANUALCP-BA250H/CP-BA2600HSetting the ClockIn this example, the clock is set for the 24-hour (0:00) display.Note:The "CLOCK" or time will flash at the push of the CLOCK button when the AC powersupply is restored after a power failure or unplugging the unit.Readjust the clock as follows.To readjust the clock:Perform "Setting the Clock" from the beginning. If the time display is flashing, step 3(for selecting the 24-hour or 12-hour display) will be skipped.To change the 24-hour or 12-hour display:1 Press the ON/STAND-BY button to turn the power on.2 Press the CLOCK button and within 5 seconds, press the MEMO-RY/SET button.3 Press the TUNING/TIME ( or ) button to select 24-hour or 12-hour display and then press the MEMORY/SET button."0:00" The 24-hour display will appear.(0:00 - 23:59)"AM 12:00" The 12-hour display will appear.(AM 12:00 - PM 11:59)"AM 0:00" The 12-hour display will appear.(AM 0:00 - PM 11:59)Note that this can only be set when the unit is first installed or it has been reset.(Refer to step 3 under "If trouble occurs")4 Press the TUNING/TIME ( or ) button to adjust the hour and thenpress the MEMORY/SET button.Press the TUNING/TIME ( or ) button once to advance the time by 1 hour.Holdit down to advance continuously.When the 12-hour display is selected, "AM" will change automatically to "PM".5 Press the TUNING/TIME ( or ) button to adjust the minutes andthen press the MEMORY/SET button.Press the TUNING/TIME ( or ) button once to advance the time by 1minute. Hold it down to change the time in 5-minute intervals.The hour will not advance even if minutes advance from "59" to "00".The clock begins counting from "0" seconds. (Seconds are not displayed.)The time display will disappear after a few seconds.To confirm the time display:Press the CLOCK button.The time display will appear for about 5 seconds.1 Clear all the programmed contents. [Perform to step 3 under "If trouble occurs"2 Perform "Setting the Clock" from the beginning.Speaker system1. Tweeter2. Woofer3. Bass Reflex Duct4. Speaker Wire34123

/ 5

Related manuals for Sharp CD-BA250H