Sharp Actius PC-MV10 Operation Manual

Also see for Actius PC-MV10: Quick setup guide

Contents

AppendixesA-14• Recovers both C: and D: drive.This process will format both C: and D: drives, and contents of the hard diskwill be restored to its original state in C: drive. The volume of the drives will beback to the same as you used for the first time.• Formats hard disk and creates new partition.This process will format whole hard disk drive and create new partition. Youcan select the volume of C: and D: drives. The contents of the hard disk will berestored to its original state in C: drive.Formatting the drives and re-installing Windows1. Make sure the computer is turned off.2. If any peripheral devices are connected to your computer, disconnect them.3. If the weight saver is installed in your computer, remove the weight saverand install the optical drive.4. Turn on the computer.5. When the message Press to enter SETUP appears, press F2. TheSetup Utility opens.6. Insert the Product Recovery CD-ROM disk 1 into the CD-ROM drive.7. In the Exit menu, select Load Setup Defaults; then, press Enter twice.8. In Boot Sequence of the Boot menu, set CD-ROM Drive to the top of thelist; then, press Esc.9. In the Exit menu, confirm Exit Saving Changes is highlighted and pressEnter twice.10. Read the message on the screen, and select the operating system which youhad selected for the first time you use the computer; then, press Enter.You cannot change the operating system from the first choice.11. Read the message on the screen, and select the way to recover your system;then, press Enter.12. Read the message and select Continue; then, press Enter.13. Read the message and select Continue again; then, press Enter.14. If you see the message asking you to insert the Product Recovery CD-ROMdisk 2, remove the disk 1 and insert the disk 2; then, press Enter.