AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-3940 5 Report output(in confidentialreception)Used to set whether the communication report table (reception) is outputted ornot in confidential reception.0 Output Initial setup6-8 Not used 00041 1,2 Send mode documentcontent print(Report table)Used to set whether part of a send document is printed on the communicationreport (send) or not in FAX send error. However, use the other soft switch to setwhether the communication report is printed or not.1 In case ofan errorInitial setup03,4 Report output(transmission)Used to set the communication report table output after transmission (except forsequential broadcast, sequential polling, relay broadcast).1 Only whentransmissionis failedInitial setup05,6 Report output(sequential broadcast,sequential polling, relaybroadcast)Used to set the communication report table output after transmission(sequential broadcast, sequential polling, relay broadcast).0 All print Initial setup17,8 Report output(reception)Used to set the communication report table output in reception (except forconfidential reception).0 PrintinhibitedInitial setup042 1-3 Not used 0004 F.A.S.T function Used to set the management function performed in FAX communicationthrough the telephone line.0 NO5-7 Not used 0008 V.34 mode function inmanual communicationUsed to set Enable/Disable of V.34 mode function in manual communication.When, however, SW43-1 is set to "1:disable," V.34 mode is disabled though thisswitch is set to "0:enable."0 Enable43 1 V.34 mode function(When call out andpolling)Used to set Enable/Disable of V.34 mode function in the machine whensending.0 EnableSWNo.BitNo.Item Switch selection and function USA Initial value Keyoperator1: Communication reporttable is not printed.0: Communication reporttable is printed.Bit No. 1 2Not print 0 0Always print 0 1In case of an error 1 0In case of an error 1 1Bit No. 3 4Print inhibited 0 0All print 0 1Only when transmission is failed 1 0Only when transmission is failed 1 1Bit No. 5 6Print inhibited 0 0All print 0 1Only address to which transmission is failed 1 0All print 1 1Bit No. 7 8Print inhibited 0 0All print 0 1Only in case of an error 1 0Print inhibited 1 11: YES 0: NO1: V.34 mode functiondisable0: V.34 mode functionenable1: V.34 mode functiondisable0: V.34 mode functionenable
