AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-18
* Dial is send with the setup value of +29ms.
* Dial is send with the setup value of +9ms.66-13Purpose SetupFunction (Content) Used to enter (set) the number for the FAX dialsignal output test. (The dial number signal setwith this simulation is outputted in the dial signaloutput test with SIM 66-14~16)(Only when FAX is installed.)Section FAXItem DataOperation/Procedure The dial test number is set.Enter a number with 10 digit key pad, * key, and# key.The upper limit is 20 digits.Press CLEAR to return to the initial state.Press START to register.66-14Purpose SetupFunction (Content) Used to set the make time in the FAX pulse dialmode (10PPS) and to test the dial signal output.(The dial number signal set with SIM 66-13 isoutputted.)Used to check dialing troubles and the operation.(Only when FAX is installed.)Section FAXItem OperationOperation/Procedure The dial test is performed. (10PPS output)The make time is set. (Set range : 0-15)When CUSTOM SETTING is pressed, theexecution is terminated.0 Execution1 Dial pulse make time setup (0 - 15)SIMULATION 66-13DIAL TEST NUMBER SETTING.INPUT NUMBER AND PRESS START.0123456789*#012345670-9:[0-9], *:[*], #:[ ]#SIMULATION 66-14DIAL TEST(10PPS). SELECT 0-1, AND PRESS START.0. EXECUTE1.MAKE TIME 1SIMULATION 66-14DIAL TEST(10PPS). SELECT 0-15, AND PRESS START.[1.MAKE TIME] 77 ; [ ms]+29SIMULATION 66-14DIAL TEST(10PPS). EXECUTING...1.MAKE TIME 7 ; [ ms]+29Select 1 and press [START] key. Press [CUSTOM SETTINGS] keyor [START] key.Select 0 andpress [START] key.Press [CUSTOM SETTINGS] key.66-15Purpose SetupFunction (Content) Used to set the make time in the FAX pulse dialmode (20PPS) and to test the dial signal output.(The dial number signal set with SIM 66-13 isoutputted.)Used to check dialing troubles and the operation.(Only when FAX is installed.)Section FAXItem OperationOperation/Procedure The dial test is performed. (20PPS output)The make time is set. (Set range : 0-15)When CUSTOM SETTINGS is pressed, theexecution is terminated.0 Execution1 Dial pulse make time setup (0 - 15)SIMULATION 66-15DIAL TEST(20PPS). SELECT 0-1, AND PRESS START.0. EXECUTE1.MAKE TIME 1SIMULATION 66-15DIAL TEST(20PPS). SELECT 0-15, AND PRESS START.[1.MAKE TIME] 77 ; [ ms]+9SIMULATION 66-15DIAL TEST(20PPS). EXECUTING...1.MAKE TIME 7 ; [ ms]+9Select 1 and press [START] key. Press [CUSTOM SETTINGS] keyor [START] key.Select 0 andpress [START] key.Press [CUSTOM SETTINGS] key.
