Sharp AR-FX12 Operation Manual

Also see for AR-FX12: Facsimile operation manual Operation manual Service manual

Contents

KEY OPERATOR PROGRAMS8-8Call timer at memory sendingWhen sending a fax by automatic transmission(See "Storing transmission jobs (memorytransmission)" on page 2-8.), this setting lets youselect the amount of time that the machine waitsbefore breaking the connection when the othermachine does not respond to your machine'scalling tone. If the other machine does not respondwithin this set time, your machine will automaticallybreak the connection. Time selections are 30seconds, 45 seconds, and 60 seconds. This settingis normally set to 45 seconds.Date/own number print position settingThis setting lets you select the position (inside oroutside the original image) of the sender's nameand number that are printed at the top of each faxpage you send. Normally OUTSIDE THEORIGINAL IMAGE is selected. To have your nameand number printed inside the original image, selectINSIDE THE ORIGINAL IMAGE. For more detailedinformation on the position of each setting, refer to"Position of sender's information" on page 3-11.Quick on line sendingWhen this setting is turned on, the machine will callthe other machine and start transmitting thedocument as soon as the first page is scanned.Transmission therefore takes place at the sametime as any further pages are being scanned.Normally this setting is turned on.If you turn the setting off, transmission will notbegin until all pages of the document have beenscanned. Note that this setting does not apply tomanual transmission. (See "Storing transmissionjobs (memory transmission)" on page 2-8.)Recall in case of line busyThis program is used to set the number of recallattempts and the interval between recall attemptswhen a transmission is not successful due to theline being busy or other reason.Normally the machine is set to make 2 recallattempts at intervals of 3 minutes.The number of recall attempts and the intervalbetween attempts that can be set in each countryare shown in the following table.Country Differentiation TableIf you do not wish recalling to take place, select[TURN OFF RECALL].Recall in case of communication errorWhen sending a document, this setting is used toselect whether your machine will re-attempt the call ifthe transmission fails due to a line error.Normally the machine is set to make 1 recallattempts at intervals of 3 minutes*1 .The number of recall attempts can be set to only 1time* 2, and the interval between attempts can beset to any number of minutes from 1 to 15. If you donot wish recalling to take place, select [TURN OFFRECALL].*1. Note that in United Kingdom, the intervalbetween attempts can be set to 1 minute.*2. Note that in United Kingdom, the number ofrecall attempts can be set to any number 1 to 5.UnitedKingdom Canada Australia andNew ZealandThe number ofrecall attempts 1 to 10 1 to 14 1 to 9The intervalbetweenattemptsany number of minutes from 1 to 15NOTEEven if this setting is turned on, your machine will notre-attempt the call when a document is sent bymanual transmission.NOTEEven if this setting is turned on, your machine will notre-attempt the call when a document is sent bymanual transmission.