Sharp 64LHP5000 Service Manual

Contents

664LHP5000PROJECTOR UNITFront Panel FunctionsA flip-down door conceals the control panel. Push gentlyand release, to open the door. To close the door, lift it backup into place.NOTE:If you accidentally pull the door, it may not shut properly. Push thedoor back in to shut it.1 POWER/DOWNLOAD indicatorLights when power is on. Flashes when downloading theGUIDE Plus+ program information.2 Timer indicatorLights GUIDE Plus+ timer is set.3 DTV indicatorLights when receiving a digital television broadcast.Flashes when downloading the DTV program information.(DTV indicator may still blink even when the power hasbeen turned off. This is not a defect.)4 OPC sensorSensor to detect the room brightness.5 POWER button (STANDBY/ON)Press once to turn on the Rear Projection HDTV. Pressagain to turn off the Rear Projection HDTV.NOTE:When the Rear Projection HDTV is turned on in DTV mode, it may takeseveral seconds before the DTV image is displayed. This is not amalfunction.6 INPUT buttonPress to select your program source. Each press of theINPUT changes the selection to the next source.In some cases, the door may only open slightly whenpushed.In such cases, open the door with your finger as shown inthe figure at left.7 CHANNEL buttonsPress plus ' or minus " to tune to a higher or lowerchannel. Only the preset channels can be tuned in usingthese buttons.8 RETURN buttonPress to set the Rear Projection HDTV to its initial mode.TV DTV INPUT 1INPUT 4 INPUT 3 INPUT 2POWERSTANDBY/ONINPUT CH RETURNPOWER/DOWN LOAD TIMER OPC51 2 3 4 6 7 8