Sharp 64LHP5000 Service Manual

Contents

3664LHP5000PROJECTOR UNIT1234167123456• Adjust the blue center to match the green center.• Overlap the blue vertical line at the center with the green vertical line.Note: Do not adjust items 6 and 7.• Adjust the interval at the center of the blue vertical line to the interval of the greenvertical line.Note: Do not adjust items 5 and 6.or10 -5 Blue line adjustment• Adjustment in the horizontal direction1st FACStart• See 4 Convergence Setting Mode in the Factory ADJ mode.• Input cross-hatch signals to this device’s video input terminal.or• Select the Adjustment itemIn particular, be aware of thesetting before adjustment.• Adjust the Data valueNote :• Repeat the adjustments until you attain theoptimum state.• Fine-adjust over the entire picture to obtain theoptimum picture.• If the adjustment of H-STATIC is not possiblewithin the range of 010 to –010, set the data valueto 0, turn the centering magnet of the deflectionyoke and fine-adjust H-STATIC.Adjustment Item Screen No. Adjustment MethodCenter-line Adjustment 12536478A9B0C"""""""Line-interval Adjustment""""""BH - STATIC» Horizontal correction adjustment of the blue lineË ScreenKeyNo.)KeyNo.1KeyNo.2• STATIC 1Fig. 9. Horizontal correction (1)• SKEW 2 • 3D SKEW 3 • 5D SKEW 4• BOW 5 • 4D BOW 6 • 6D BOW 7KeyNo.8KeyNo.7• SIZE 8 • MID SIZE 9 • 5D SIZE 10• LIN 11 • MID LIN 12 • 6D LIN 13» Screen’s changes in the horizontal direction when manual convergenceadjustment is modeThe changes at the arrow parts shown below are those implemented usingthe Volume ± key. Changes are opposite to the arrow when the Volume —key is used.= Fixed positionREDOFFGREENONBLUEONGREEN + BLUEBH-STATICBH-SKEWBH-BOWBH-3D SKEWBH-4D BOWBH-5D SKEWBH-6D BOWBH-SIZEBH-LINBH-MID SIZEBH-MID LIN(BH-5D SIZE)(BH-6D LIN)