Sealey ms155 Instructions Manual

instructions forvACUUM OIL & FLUID EXTRACTOR MANUAL 1.6LTRmodel no: Ms155Thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. sAFETy99 9Keep the extractor clean and maintain it in good condition (use an authorised service agent).9 replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.9 Keep all non-essential persons away from the work area.99 9check extractor connections and fittings before use.99 9ensure that the tank capacity exceeds the amount of fluid to be collected.98 9DO NOT use the extractor for any purpose other than that for which it is designed.99 9DO NOT operate the extractor if any parts are damaged or missing as this may cause failure and/or personal injury.9 9WARNING! Engine oil maybe hot when extracting.▲ ImpoRtANt! Ensure that you wear protective clothing, gloves, goggles, face mask as appropriate for the fluid being extracted.9 9WARNING! Do Not allow uncontrolled discharge of fluids thus polluting the environment.9 dispose of waste fluids in accordance with local authority regulations.9 9WARNING! Do Not use with gasoline or other flammable liquids.98 9DO NOT use the unit to extract dangerous chemicals, poisons, acids, alkalines or solvents.98 9the container is not designed for long term storage.98 9DO NOT store the unit under extreme conditions.98 9DO NOT turn the container upside down when it is holding fluids.98 9DO NOT adapt the unit for any other purpose.98 9When not in use, store in a safe, dry, childproof area.2. INTRODUCTION1.6 lt capacity, constructed from composite materials, suitable for the extraction of engine or transmission oils from cars, motorcycles, marineengines, stationary engines and industrial machinery. Also suitable for low viscosity fluids such as water. Supplied with two suction probesand cover cap. use probes to remove engine oil through the dipstick tube.3. spECIFICATIONsModel no: ...................................................................Ms155capacity: ........................................................................ 1.6ltrsuction probes: ............Ø8mm x 1300mm, Ø5mm x 1008mmFig.1ms155| issue 1 22/07/15Original Language Version© Jack sealey limitedrefer toinstructionmanual

/ 2

Related manuals for Sealey ms155