Sealey Worksafe 2005V/12 Quick Start Manual

FFP2 FACE MASK WITH VALVEPACK OF 12MODEL NO: 2005V/12Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY9 Ensure that all components are in good order and fit for purpose. DO NOT use if you are unsure.9 The mask is for single use only, and should not be removed from its packaging until it is required for use.9 Wear the mask for the whole period of exposure. It should not be used for more than 8 hours (1 shift) and should be discarded safelyand appropriately after use. WARNING! The user should be instructed on how to fit the mask properly and made aware of these instructions before using themask. WARNING! Use only in adequately ventilated areas which DO NOT have a deficiency of oxygen. WARNING! Facial hair or beards and certain facial characteristics may reduce the effectiveness of the mask. WARNING! If the mask is removed whilst in the contaminated area it should be replaced. WARNING! If the mask is damaged in use it must be replaced.8 DO NOT use the mask in an explosive environment.8 DO NOT store or transport masks in direct sunlight. Store in frost free, dry conditions.NOTE: If the User exhibits an allergic reaction to the mask, they must leave the hazard area and seek medical advice.2. INTRODUCTIONPack of 12 cup masks class FFP2 NR. Protects against mild toxic or irritant solid and liquid aerosols. Aerosols are defined as asuspension of fine solid particles or liquid droplets in air or another gas. Fitted with nose liner and aluminium nose clip to fit all facecontours. Also fitted with breathing vent to provide more comfort and better communication as well as reducing heat build-up. Filterefficiency ≥ 94%. Manufactured to BS EN 149:2001 + A1:2009.3. SPECIFICATIONModel No: ...............................................................2005V/12Brand: ..................................................................... WorksafeQuantity: ............................................................................ 124. FITTING INSTRUCTIONS4.1. Cup mask in one hand with nose piece at fingertips, allow the headbands to hang freely below the hand (fig.1.1)4.2. Hold mask under chin with nose piece upwards (fig.1.2)4.3. Locate the upper strap across the crown of the head and the lower below the ears, straps must not be twisted (fig.1.2/3/4).4.4. Using both hands, mould the nose clip to the lower part of the nose to ensure a close fit and good seal. Pinching the nose clip usingonly one hand may result in less effective performance (fig.1.5).4.5. ` The mask seal on the face should be fit checked before entering the workplace (fig.1.6).4.6. If the user feels that the straps are too loose and not possible to achieve a satisfactory seal, the straps may be knotted to shortenthem.2005V/12 Issue 1 21/10/20Original Language Version© Jack Sealey Limitedfig.12 36154CE 2797

/ 2

Related manuals for Sealey Worksafe 2005V/12