Sealey WL483D.V2 Manual

BENCH MOUNTING MAGNIFYING WORKLIGHT12W SMD LEDMODEL NO: WL483D.V2Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY1.1. ELECTRICAL SAFETY WARNING! It is the user’s responsibility to check the following:You must check the Power Adaptor to ensure that it is safe before using.You must ensure the risk of electric shock is minimised by the installation of appropriate safety devices. An RCCB (Residual CurrentCircuit Breaker) should be incorporated in the main distribution board.We recommend that an RCD (Residual Current Device) is used with all electrical products. It is particularly important to use an RCDwith portable products that plug into an electrical supply not protected by an RCCB. If in doubt consult a qualified electrician. Youcan obtain a Residual Current Device through your Sealey stockist. You must read and understand instructions concerning electricalsafety.The Electricity At Work Act 1989 requires all portable electrical appliances, if used on business premises, to be tested by a qualifiedperson, using a Portable Appliance Tester (PAT), at least once a year.The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of the appliance andthe safety of the appliance operator. If in any doubt about electrical safety, contact a qualified electrician.9 Ensure that the insulation on all cables and the product itself is safe before connecting to the mains power supply.9 Ensure that cables are always protected against short circuit and overload.2. INTRODUCTIONPowerful 3 dioptre 120mm precision lens gives high quality magnifying capabilities. Features 48 SMD LEDs to illuminate the objectfor improved detailed work. Multi-position swing arm allows simple positioning of lamp to suit task. Features a G-clamp base to secureto a workbench or table. Ideal for electrical engineers, engravers and fine detail work. Supplied with BS power adaptor.3. SPECIFICATIONModel No: ...................................................WL483D.V2LED Type ............................................................... SMDSupply: ....................... 12V DC Transformer 230V~50Hz4. OPERATION4.1. MOUNTING4.1.1. Fix the clamp to a secure surface. See fig.1.4.1.2. Lower the work light assembly into the clamp, use two hands to prevent the lamp moving during this operation.4.1.3. Turn on/off using the switch on top. See fig.2.4.1.4. Adjust by loosening/tightening the head clamp. See fig.3.NOTE: Be aware of the effect of using the lamp close toa window/door where it could be in direct sunlight.4.1.5. Connect the Power adapter lead into the flying lead at thebase of the unit.4.1.6. Remember to close the lid on top whilst it is not in use.fig.2fig.1WL483D.V2 Issue 3(3) 15/09/23Original Language Version© Jack Sealey LimitedRefer toinstructionmanual

/ 2

Related manuals for Sealey WL483D.V2