Sealey SL1D.V2 Instructions Manual

INSTRUCTIONS FOR:LOCKERS - 1 DOOR, 2 DOOR, 4 DOORMODEL No's: SL1D.V2, SL2D.V2, SL4D.V2Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions andproperly maintained, give you years of trouble free performance.1. SAFETY INSTRUCTIONSIMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSEDAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.2. INTRODUCTION WARNING! Ensure Health & Safety, local authority, andgeneral workshop practice regulations are adhered to whenusing these lockers. Locate locker in a suitable work area. Keep the work area clean, uncluttered and ensure there isadequate lighting. WARNING! Use locker on level and solid ground, preferablyconcrete. Keep the locker clean and tidy in accordance with goodworkshop practice. Keep children and unauthorised persons away from the work area. DO NOT use the locker for any purpose other than that forwhich it is designed. DO NOT use the locker outdoors. DO NOT get the locker wet or use in damp or wet locations orareas where there is condensation. DO NOT clean the locker with any solvents which may damagethe surfaces or the protective coating.2.1. Introduction:A range of lockers suitable for a variety of commercialapplications. Single and two door models fitted with a hangingbar, single door model also has single shelf. Doors on all modelsare ventilated and fitted with cylinder locks, 2 sets of keyssupplied per lock. Supplied flat packed.2.2. Dimensions:Width: 380mm, Depth: 450mm, Height: 1850mm.3. ASSEMBLY3.1. Lay out the back panel and the two side panels. The sidepanels have a cut-out at the front and a lip at the bottom.Slide the back panel into one of the side panels from the top(fig.1) and slide it all the way down (fig.2) - note that the shelfbrackets line up.fig.1fig.23.2. Fit the other side panel to the back panel following the sameprocedure. Ensure that the side panels are supported in anupright position so that the panels are not twisted.3.3. Carefully stand the unit up, again ensuring that the panels arenot twisted, two people may be required for this.fig.2Original Language Version SL1D.V2, SL2D.V2, SL4D.V2 Issue: 1 - 13/08/13© Jack Sealey Limited

/ 2

Related manuals for Sealey 5051747497436