Sealey AP6601.V2 Instructions Manual

INSTRUCTIONS FOR:MID-BOX/TOPCHEST/ROLLCAB -HEAVY DUTYMODEL No's: AP6601.V2/6610.V2/6612.V2Thank you for purchasing a Sealey product. Manufactured to a high standard these products will, if used according to these instructions andproperly maintained, give you years of trouble free performance.1. SAFETY INSTRUCTIONSIMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCTS CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH THEY ARE INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGEAND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.1.1. GENERAL SAFETY WARNING! Ensure Health & Safety, local authority, andgeneral workshop practice regulations are adhered to whenusing these units. Locate the units in a suitable work area. Keep the work area clean, uncluttered and ensure there isadequate lighting. WARNING! Use the Rollcab on level and solid ground,preferably concrete. Keep the units clean and tidy in accordance with goodworkshop practice. Keep children and unauthorised persons away from the workarea. DO NOT use these units for any purpose other than thatfor which they are designed. DO NOT use the units outdoors. DO NOT place the units in a damp or wet location or anarea where there is condensation. DO NOT clean the units with any solvents which maydamage the surfaces or the protective coating. DO NOT move the units with the drawers out. To avoidtipping, open one drawer at a time and close and secure alldrawers whilst moving the rollcab. DO NOT step on the drawers. DO NOT overload the drawers, weight limit per drawer is36kg.© Jack Sealey LimitedAP6612.V2AP6610.V2AP6601.V2Original Language Version AP6601.V2, 6610.V2, 6612.V2 Issue: 1- 12/07/162. ASSEMBLY AND USE2.1. These units are heavy, obtain the help of at least one other person before attempting to unpack them.(AP6612.V2)2.2. Attach the wheels to the bottom of the rollcab using 4 bolts, washers and spacers (if supplied) per wheel.The braked swivel wheels should be mounted on the same end as the handle (left hand side), the normal swivel wheelsin the middle and the locked wheels at the far end (fig.1).2.3. Mount the side mounted handle onto the cabinet and attach with 4 bolts and washers (fig.3).(All units)2.4. AP6610.V2 or AP6601.V2 can be placed on top of AP6612.V2, alternatively all 3 units can be assembled together as inthe picture below.2.5. To remove a drawer with roller sliders, pull the drawer completely out, press down the left tab and lift up the right tab, pulldrawer off the slides (fig.2). To reinstall the drawer, realign with the internal drawer slide and push until it locks in place.IMPORTANT: To avoid tipping, open one drawer at a time and close and secure all drawers whilst moving the rollcab/units.2.6. Periodically lubricate wheel axles and tighten all nuts and bolts.

/ 2

Related manuals for Sealey 6610.V2