Menu
Sealey PPD100 Quick Manual
  |
100MM 2-STROKE PETROL POST DRIVERMODEL NO: PPD100Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY1.1. GENERAL SAFETY WARNING! Stop the engine and disconnect the spark plug before changing accessories or performing any maintenance. WARNING! DO NOT operate the driver if damaged. Replace or repair using recommended parts only. Unauthorised parts maybe dangerous and will invalidate your warranty. Use authorised Service agent only.9 Keep the driver in good condition. Regular maintenance will give the best and safest performance.9 Wear appropriate PPE when using driver.8 DO NOT allow children or untrained persons to operate the driver. Children should be supervised to ensure that they DO NOT playwith the machine.9 The machine can be used by people with reduced physical, sensory or mental capabilities or lack of experience and knowledge if theyhave been given supervision or instruction concerning use of the machine in a safe way and understand the hazards involved.8 DO NOT jam the operating trigger in the operating position and DO NOT pull the trigger without holding the driver firmly in both hands.8 DO NOT use the driver if you are tired or under the influence of alcohol, drugs or intoxicating medication.9 When not in use, disconnect the spark plug. Drain off any unused fuel into suitable container and dispose of according to localregulations. Clean and dry the driver and store in case.1.2. ENGINE SAFETY WARNING! Check the engine oil level before each start-up. Only use approved oil. Never operate the engine with insufficient oil. WARNING! DO NOT touch spark plug or plug lead whilst the engine is running; severe, potentially fatal, electric shock may result.9 Ensure that only the correct fuel type and grade is used.8 DO NOT check ignition system by removing the spark plug or spark plug lead. Use specific tester or contact service agent.8 DO NOT operate the driver in an enclosed area as the motor exhaust fumes are a health hazard. Always ensure adequate ventilation.8 DO NOT leave the driver unattended whilst operating, and DO NOT remove the fuel cap whilst the engine is running.8 DO NOT refuel the engine whilst it is running. Stop the engine and allow it to cool for two minutes before attempting to refuel.8 DO NOT refuel in a closed or poorly ventilated environment as there is a danger of explosion or fire. Refuel outdoors only.8 DO NOT smoke or place the driver near any naked flames whilst re-fuelling.8 DO NOT operate driver if there is a fuel leak. Move the unit and avoid using until the leak has been fixed and the machine is dry.8 DO NOT start the engine if there are any flammable materials near the exhaust system or in the path of the exhaust gases.8 DO NOT block the engine ventilation grilles.9 Ensure engine fuel is stored in an approved container.9 For long term storage ensure the fuel is drained and that the driver is adequately protected against frost.8 DO NOT operate the engine with the air filter removed.8 DO NOT touch the engine during or after use. To avoid burns, allow it to cool before handling.2. INTRODUCTIONHeavy-duty and easy-to-use post driver, designed to knock posts up to Ø100mm diameter in to the ground. Powered by a lightweight, compactand powerful 2-stroke 52cc air cooled single cylinder engine. Recoil start and a fuel capacity of 1.3L. Supplied with three sets of post rings: 20x Ø49mm, 50 x Ø69mm, 70 x Ø100mm, allowing the machine to be used with a wide range of diameter posts. Supplied complete with storagecase with integral wheels for ease of transport, as well as full tool kit, spare grease and fuel mixing container.3. SPECIFICATIONModel No.: ................................................................PPD100Engine capacity:............................................................. 52ccEngine type: ...................... single cylinder air cooled 2-strokeFuel consumption: .......................................................0.6L/hrFuel tank: ............................................... 2-Stroke 25:1 (1.3L)Impact energy: ............................................................ 20-55JImpact frequency: ............................................. 700:1350rpmMaximum power: .............................................. 2HP 9000rpmMaximum torque: ..........................................2.5Nm 5000rpmNoise rating: ................................................. LWA112, 1dB(A)PPD100 Issue 1 29/03/21Original Language Version© Jack Sealey LimitedRefer toinstructionsHot surfacesWear eyeprotectionWear protectiveglovesWear earprotectionWear safetyfootwearWear protectiveclothingVibration/Uncertainty ................................. 13.89m/s²/1.5m/s² |
Related manuals for Sealey PPD100
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved