Sealey HVD16 Instructions Manual

16” HIGH VELOCITY DRUM FANMODEL NO: HVD16Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPPORRTATANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHHE PPROODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPEERSSONNAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY1.1. ELECTRICAL SAFETY WARNING! It is the user’s responsibility to check the following:Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and allelectrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electricalproducts. You may obtain an RCD by contacting your local Sealey stockist.If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (PortableAppliance Test) tested.Electrical safety information: it is important that the following information is read and understood.1.1.1. Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.1.1.2. Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.1.1.3. Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with thecorrect fuse - see fuse rating in these instructions. DO NOT pull or carry the appliance by the power cable. DO NOT pull the plug from the socket by the cable. DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired orreplaced immediately by a qualified electrician.1.1.4. This product is fitted with a BS1363/A 13 Amp 3 pin plug.If the cable or plug is damaged during use, switch the electricity supply and remove from use.Ensure that repairs are carried out by a qualified electrician.Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.A) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.B) Connect the BROWN live wire to the live terminal ‘L’.C) Connect the BLUE neutral wire to the neutral terminal ‘N’.Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.Sealey recommend that repairs are carried out by a qualified electrician.1.2. GENERAL SAFETY Disconnect the fan from the mains power when not in use and before servicing or performing any maintenance. Use the fan in dry areas only. DO NOT use in wet or areas with high condensation such as showers, pools etc. WARNING! If the fan falls into water or any other liquid, immediately switch off and disconnect from the mains power supply.DO NOT touch the fan until the mains power supply has been disconnected. Always disconnect the fan from the power supply when moving from one location to another and ensure fan is stood on a levelsurface. The fan air flow is powerful. Before use ensure that there is nothing nearby that will be damaged or displaced by the stream of air. Keep the fan clean and maintained in good condition. For motor service, contact an authorised service agent. Use recommended parts only. Unapproved parts may be dangerous, and will invalidate your warranty. DO NOT operate the fan where there are explosive or flammable gases, fumes or other hazardous substances. DO NOT stand the fan on the power cable. DO NOT insert any objects through the fan guard. DO NOT cover the fan when in use. DO NOT immerse the fan in water or any other liquid. DO NOT allow children to operate the fan. DO NOT stand the fan where it may be knocked over or off a surface, or where the lead may cause a person to trip. DO NOT use the fan outdoors. DO NOT modify speed control or attempt to fit any additional external speed control device to the fan. When not in use place the fan in original box, or otherwise cover to protect from dust and store in a safe, dry, childproof location.Replacement fuserating:HVD16 Issue 1 15/02/21Original Language Version© Jack Sealey LimitedRefer toinstructionsIndoor UseOnly

/ 2

Related manuals for Sealey HVD16