Sealey DF760.V2 Manual

Also see for DF760.V2: Instructions

BENCH MOUNTING SHEET METAL FOLDER 760MMMODEL NO: DF760.V2Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY9 Wear approved safety goggles when operating. Your local Sealey stockist offers a complete range of safety equipment.9 Use the tool only for its intended purpose.9 Check regularly for damaged parts. DO NOT use if any of its components are broken, worn or damaged.9 Use original Sealey spare parts and accessories. Use of non-recommended spare parts may be dangerous and will invalidatewarranty.8 DO NOT operate this tool while under the influence of drugs, alcohol or other impairing medication.8 DO NOT Allow unqualified persons to operate the metal folder. Keep children away from the tool.2. i INTRODUCTIONBench mounted sheet metal folder, fitted with mounted plates. Capable of bending up to17 gauge steel sheet. Ideal for the small garage or restoration operation.3. i SPECIFICATIONMaximum sheet size:.....................................................760mmMaximum sheet thickness: ..........................................17gaugeMaximum bending angle: .................................................... 900Length of unit:................................................................800mmWidth of unit: .................................................................150mmHeight of unit: ..................................................................73mm4. CONTENTS & ASSEMBLY4.1. Unpack the unit and check that all parts are included and not damaged. Should you experience a problem contact your supplierimmediately.NOTE: Numbers in brackets refer to item numbers on the parts diagram.4.2. The stand (1) should be secured to a work bench using the mounting holes and 4 bolts (3/8” diameter).4.3. Each handle ball (7) should be attached to the handle lever (6) and the handle levers should be placed into the pins (5).5. OPERATION5.1. To use the bender, lower the handle lever until the moving plate is parallel to the work bench. Position the material to be bent on thesupporting plate (2) and the moving plate (4) and properly align with the edge to be bent up against the back edge of the supporting plate.5.2. Place and secure the pressing plate (3) on top of the supporting plate with the back edge of pressing plate aligned with backedge of supporting plate. Suitable clamps (not included) are required to secure the pressing plate. For our full range of clamps see www.sealey.co.uk5.3. Raise the two handle levers to bend the material to the desired angle.5.4. When the folder is not in use, it should be covered and stored in a dry location.Original Language Version© Jack Sealey LimitedRefer toinstructionmanualWear protectivegloves Wear eyeprotection Wear protectiveclothingWear protectivefootwearItem Part No. Description1 DF760.V2-01 Stand complete (includes items 1, 2, 4, 5)3 DF760.V2-03 Pressing Plate6 DF760.V2-06 Handle lever7 DF760.V2-07 Handle knobDF760.V2 Issue No: 4 01/03/21

/ 2

Related manuals for Sealey DF760.V2