Sealey D200T Quick Start Manual
PORTABLE DIESEL TANK 200LTR 12VMODEL NO: D200TThank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY WARNING! this tank must ONLY be used for diesel fuel.9 Place the tank on a flat surface before filling.9 Secure the tank to strong points with ratchet straps before transporting in or on a vehicle.9 Maintain the pump in good condition (use an authorised service agent).9 Replace or repair damaged parts. Use recommended parts only. Non authorised parts may be dangerous and will invalidate the warranty.9 Keep the pump clean for best and safest performance.9 Ensure the power supply (vehicle battery) corresponds with the requirements of the pump (12V DC).9 Disconnect from battery when not in use.9 Wear protective gloves, and protective clothing when working around fuel. A full range of personal safety equipment is available from yourlocal Sealey Stockist.9 Keep children and unauthorised persons away from the working area.8 DO NOT place the tank near any heat source.8 DO NOT start or stop the pump by connecting or disconnecting the batteryclamps.8 DO NOT allow the unit to get wet.8 DO NOT operate the pump with wet hands.8 DO NOT use the pump where explosive or flammable vapours may bepresent.8 DO NOT tamper with the pump connections.2. INTRODUCTIONManufactured from HDPE for the safe transportation and dispensing of dieselfuel when supplying on site equipment. Complies to ADR 1.1.3.1.C for exemptionfrom requirements of ADR regulations. Supplied with a 12V electric pump, 4mtrelectric cable and clamps and a 4mtr delivery hose with automatic fuel nozzle.Can be safely secured and transported on a pick-up truck or van, using groovesfor tie-down straps and 6 handles for positioning. Supplied with lockable cover.Not suitable for petrol.3. SPECIFICATIONModel No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . D200TVoltage:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12VCurrent:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15APower: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 180WTank Capacity: . . . . . . . . . . . . . . . . . . . . . . . . . . . 200ltrFlow Rate: . . . . . . . . . . . . . . . . . . . . . . . . . . . .20ltr/minDuty Cycle: . . . . . . . . . . . . . . . . . 30mins on/30mins offDimensions (W x D x H): . . . . . . . 1100 x 800 x 470mmNett Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . 30.42kgD200T | Issue 1 26/11/18Original Language Version© Jack Sealey LimitedRefer toinstructionsWear protectiveglovesWear protectiveclothingKey: (fig.1. & fig.1A).1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Breather Lid2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Pump On/Off Switch3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Battery Clips4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Automatic Fluid Nozzle5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Securing Strap Locations6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Vent Plug7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Fork Locations8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Moulded Hand Holds12345567788Wear safetyfootwearfig.1fig.1A |
Related manuals for Sealey D200T
This manual is suitable for:
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved