Sealey Auto Service Line VS2030 Instructions Manual

 WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are adhered to when usingthis equipment. Read instructions thoroughly to ensure safe and effective use. Important! Read instructions in conjunction withvehicle or equipment manufacturer's workshop manual. Maintain the apparatus in good condition (use an authorised service agent). Before each use check condition of eachcomponent. If any component is damaged, replace immediately. Use genuine parts only. Unauthorised parts may notfunction correctly and will invalidate the warranty. Use in a suitable work area. Keep area free from unrelated materials and ensure that there is adequate lighting. WARNING! Always wear approved eye (or face) and hand protection when pressure leakage testing. Keep children and unauthorised persons away from the working area. DO NOT operate the leakage tester when you are tired or under the influence of alcohol, drugs or intoxicatingmedication. DO NOT clean the equipment with solvents or other harsh chemicals. DO NOT use the leakage tester for any purpose other than that for which it is designed. When not in use return parts to the case, and store it in a safe, dry, childproof location.InStRUctIonS foR: TURBOSYSTEM LEAKAGE TESTERModEl no: VS2030thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properlymaintained, give you years of trouble free performance.1. SAFETY INSTRUCTIONSIMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.2. DESCRIPTIONdesigned to charge the turbo system with a low pressure of regulated workshop mains air supply; to indicate the presence of leakswithin the system. the kit includes a pressure gauge, a shut off ball valve, a pressure relief valve, a mains air male barbed quickcoupler and four pairs of system stepped adaptors for use on a wide range of hose sizes. the kit can also be used on coolingsystem hoses. All items supplied in a storage case.Original Language Version VS2030 Issue: 1 - 21/11/12© Jack Sealey limited4. CONTENTSQuick couplerconnection.Pressure relief valveat rear of regulator.Pressure regulatorand gaugeflexible hosecoupled to adaptor3. TECHNICAL SPECIFICATIONSPart no Adaptor sizesVS2030.01 Ø80/85/90mmVS2030.02 Ø65/70/75mmVS2030.03 Ø50/55/60mmVS2030.04 Ø35/40/45mm25psi (1.7bar)maximumZeroBall valve(open)AdaptorVernier(not supplied)tapered stepped spigot adaptors (system plug)tapered stepped spigot adaptors (system inlet)nominal bore sizesØ80/85/90nominal bore sizesØ65/70/75 nominal bore sizesØ35/40/45nominal bore sizesØ50/55/60

/ 2

Related manuals for Sealey Auto Service Line VS2030