Sealey AK468DXP Instructions Manual

64L LOW LEVEL OIL DRAINER WITH PUMPMODEL NO: AK468DXPThank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY9 Replace damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.9 Keep the drainer clean, dry and in good condition for best and safest performance.9 Wear appropriate protective clothing and eye protection.9 If it is necessary to raise the vehicle ensure that it is properly supported. If the vehicle has been raised with a jack, axle stands mustbe put in place before working under the vehicle.9 Remove the oil drainer and other tools and equipment from underneath the vehicle before lowering it again.9 Use drainer in a suitable work area. Keep area clean and tidy, and free from unrelated materials and ensure that there is adequatelighting.9 The work area should have a flat and level surface capable of supporting the weight of the drainer and it’s contents.8 DO NOT position the drainer in such a way that it becomes a hazard to others in the work area.9 Ensure that the floor is not slippery and wear non-slip shoes.9 Keep children and unauthorised persons away from the work area.9 Dispose of waste liquids in accordance with local authority regulations. WARNING! DO NOT allow uncontrolled discharge of fluids which would pollute the environment.8 DO NOT use the drainer in wet or damp areas or where condensation is present.8 DO NOT use the drainer near open flames or other sources of heat. WARNING! If draining the oil whilst hot, take precautions to prevent against burns, particularly hands, wrists and arms.2. INTRODUCTIONLow level drainer suitable for use on the forecourt and workshop floor. High impact polypropylene fabricated unit with a capacity of 64L. Fittedrotary pump and 2.4m hose for fast discharge. Fully portable with four castor wheels and handle for manoeuvring around the workshop.3. SPECIFICATIONModel No:............................................................AK468DXPCapacity: .......................................................................... 64LGravity Discharge: ........................................................... YesGravity Feed: ................................................................... YesMaximum Height to Pan: ............................................ 250mmPump Discharge: ............................................................. YesSuction Probe: .................................................................. No4. ASSEMBLY4.1. Refer to parts diagram.4.2. To mount the handle (3) and pump (18), you will need to partially disassemble the rear mounting plate (9).4.3. Remove right castor wheel nut (5) from castor (23) and slide out the mounting plate (9).4.4. Attach handle (3) to mounting plate (9) using screw (8).4.5. Attach pump (18) via the mounting bracket to the mounting plate (9) using the nuts and bolts provided.4.6. Re-attach mounting plate (9) and right castor.4.7. Attach short hose (12) to connector (11) on bottom of pump (18) and bottom of reservoir (7) with hose clamp (14).4.8. Attach long hose (24) to connector (11) on top of pump (18) with connector (11).AK468DXP Issue 1 06/01/2021Original Language Version© Jack Sealey LimitedRefer toinstructionsWear eyeprotectionWear protectiveglovesWear protectiveclothing

/ 2

Related manuals for Sealey AK468DXP