Sealey AK459DX.V2 Instructions Manual
Also see for AK459DX.V2: Manual
INSTRUCTIONS FOR:AK459DX.V2Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructionsand properly maintained, give you years of trouble free performance.AK459DX.V2 - 1- 1602061. SAFETY INSTRUCTIONSIMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSEDAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.2. INTRODUCTION1.1. GENERAL SAFETY! WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment." Familiarise yourself with the application and limitations of the oil drainer, as well as the potential hazards.! WARNING! Disconnect the drainer from the air supply before changing accessories, servicing or performing any maintenance." Maintain the drainer in good condition (use an authorised service agent)." Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty." Keep the work area clean, uncluttered and ensure there is adequate lighting." Keep the drainer clean for best and safest performance." Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.!! WARNING! While extracting high temperature oils, keep hands, face and body protected using suitable personal protective equipment (PPE)." Keep children and unauthorised persons away from the work area.! WARNING! Ensure correct air pressure is maintained and not exceeded." Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use, and ensure that all connections are secure.# DO NOT extract caustic or flammable products.# DO NOT use the drainer for any purpose other than that for which it is designed.# DO NOT operate the drainer if any parts are damaged or missing as this may cause failure and/or personal injury.# DO NOT stand on the drainer.# DO NOT adjust or tamper with the safety valve.# DO NOT move the drainer by the hose, or yank the hose from the air supply.# DO NOT place attachments close to your face (especially eyes, ears, etc.) and do not point hose at other persons or animals.# DO NOT allow untrained persons to operate the drainer.# DO NOT operate the drainer when you are tired or under the influence of alcohol, drugs or intoxicating medication.# DO NOT leave the drainer operating unattended.# DO NOT direct air from the air hose at yourself or others." When not in use disconnect from the air supply, vent reservoir and store in a safe, dry, childproof area." Dispose of waste oil in accordance with local authority regulations.! WARNING! DO NOT pollute the environment by allowing uncontrolled discharge of waste oil.$$ DANGER! DO NOT release drain pan clamp lever when there is pressure in the reservoir as pipe and drain pan will be propelledupward with force. This could result in damage and/or serious injury.GRAVITY & SUCTION FEED/AIR DISCHARGE OIL DRAINER3. ASSEMBLY Fig. 1Fig. 2Steel fabricated 90ltr reservoir. Height adjustable steel drain pan fitted with plastic filter tray. Gravityfeed reservoir with air discharge. Includes quick-release oil dipstick probes, plus adaptors for BMWand Volkswagen, powered by venturi suction pump. Fitted with reservoir oil level indicator tube.Heavy-duty wheels and castors for easy mobility.Fig. 3 12Fig. 13.1.1 Fit the venturi pump and gauge assembly to the resevoir tank,ensure the gasket is properly positioned. Tighten the nut usinga suitable wrench (Fig. 1.1).3.1.2 Connect the drain hose with the ball valve adaptor on the baseof the resevoir (Fig. 2.1). Secure the hose with the hose clampprovided.3.1.3 Connect the drain pan (Fig. 3.1) to the ball valve (Fig. 3.2).Insert the assembled group into the resevoir tank and tightenthe ring sleeve (Fig. 3D). Adjust the height and lock in positionusing the hand wheel lock (Fig. 3E).1 |
Related manuals for Sealey AK459DX.V2
Sealey AK451DX Instructions Manual
Sealey SMC01.V2 Instructions Manual
Sealey SPI3S V2 Instructions Manual
Sealey SPBC8.V2 Instructions Manual
Sealey BOOST120.V2 Instructions Manual
Sealey SMC01 Instructions Manual
Sealey SCI6S Instructions Manual
Sealey SMC04 Instructions Manual
Sealey SPI1S Instructions Manual
Sealey SDC75 Instructions Manual
This manual is suitable for:
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved