Sealey 6-24V AUTO PROBE PLUS Quick Start Manual

6-24V AUTO PROBE PLUSMODEL NO: PPX.V4Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY8 DO NOT use the unit around explosive gas, vapor, or dust.8 When the rock switch is pressed (or rocked), battery current is conducted directly to the tip which may cause sparks whencontacting ground or certain circuits.8 The unit is not to be used with 110/220-volt domestic mains supply, it is only for use with DC 6 - 24V systems.8 DO NOT use on AC voltage.9 After working on a vehicle, correctly restore all the connections which were disconnected.9 Always follow the instructions and procedures indicated in the manufacturer’s service manual before attempting to disconnect anypart or subsystem of the electrical circuit.9 Use caution when using the unit to perform measurement. Never touch any dangerous part of the vehicle, for safety.8 DO NOT touch any live conductor with hand or skin.8 DO NOT use probe if it is damaged.9 Some components of vehicle work on lower voltage, they can not withstand the voltage applied by the unit. To avoid damage tothese components, don’t use the unit to apply voltage to them directly or indirectly.9 Before driving vehicle, always make sure that the vehicle is safe and reliable.8 DO NOT use the unit if the vehicle is being driven.2. INTRODUCTION6-24V Auto Probe with an integral work light to aid use in dark engine bays plus an audible circuit tester for when the LED on the probe cannotbe seen.3. FEATURES1 Red battery clip2 Black battery clip3 Probe4 Work lights5 ‘Touch contact’ to turn on the lights6 Test indicator7 Rock switchIt includes a front part “ - “, and a rear part “= “.When pressed the front part” - “, the probe is connected tothe red battery clip directly.When you press the rear part”=”, the probe is connected tothe black battery clip directly.8 Auxiliary ground lead4. OPERATION4.1. CONNECTION4.1.1. Unroll the unit’s cable. Clamp the red battery clip to the positiveterminal of the vehicle’s battery.4.1.2. Clamp the black battery clip to the negative terminal of thevehicle’s battery.4.1.3. The unit starts self-test, the built-in buzzer sounds,the test indicator’s green light, red light and thework lights light in turn.4.1.4. Several seconds later, the self-test finishes.Note: The buzzer sounds continuously and then sounds intermittently.PPX.V4 Issue 1 06/06/22Original Language Version© Jack Sealey LimitedRefer toinstructionsWear eyeprotection

/ 4

Related manuals for Sealey 6-24V AUTO PROBE PLUS