Sealey AK4013 Quick Start Manual

3-60V INTEGRATED TEST LIGHT/VOLTMETERMODEL NO: AK4013Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY WARNING! DO NOT use test light with domestic 110-230Volt supplies. Only use with DC Voltages between 3 and 60Volts.9 Observe standard workshop safety procedures when using the meter.9 Keep the work area clean, uncluttered and ensure there is adequate lighting. Keep tools and other items away from the engine and9 ensure you can see the working parts of the engine clearly.9 Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.9 Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery. Contain or tie back long hair.9 Ensure extension leads and probes are kept clear of hot surfaces and rotating parts.8 DO NOT drape cables around neck or arms – danger of entanglement.8 DO NOT disassemble meter.8 DO NOT get test light wet or use in damp or wet locations or areas where there is condensation.8 DO NOT use the meter for any purpose other than for which it is designed.8 DO NOT use the meter if damaged.9 When not in use, store tester in a safe, dry, childproof location.2. INTRODUCTIONIdentifies the polarity of the circuit being tested on the LCD, red for positive and green for negative. Wire hook probe design, makes piercing wireinsulation easier, the hook can be locked out of the way when probing terminals. LCD meter draws minute currents making this tool safe arounddelicate electronic components. With a range of 3-60V DC, this tool is suitable for motorcycle, car, mild hybrid and commercial vehicles. Suppliedwith 3m coiled cable and insulated crocodile earth clamp. Do not use on airbags. Battery 1 x CR2032 (supplied).3. SPECIFICATIONModel No.:................................................................ AK4013Accuracy: ............................................................ ±(1%+0.3V)Computer Safe: ..................................Testing current < 10mARange: .......................................................... 03-60V DC4. OPERATION4.1. VOLTAGE MEASUREMENT4.1.1. Push down the hook and rotate it clockwise to expose the testing probe.4.1.2. Contact the probe to the 3 ~ 60V DC voltage source.4.1.3. Connect the test probe to positive and clip to the negative of the test object or circuit. The voltage value and “+” will be displayed onthe LCD with a “Red” background when the circuit is live.4.1.4. Connect the test probe to negative and clip to the positive of the test object or circuit. The voltage value and “-” will be displayed onLCD with “Green” background when the circuit is live.NOTE: If user removes the probe away from the voltage source, the measured value will be held on the LCD about 3 seconds.AK4013 Issue 2 (2,3,4) 28/04/23Original Language Version© Jack Sealey LimitedRefer toinstructionsWear eyeprotectionThe hook can be used toselect and pull the wireout from multiple wiressafely.Fig.1Fig.2

/ 2

Related manuals for Sealey AK4013