53Remote controlThis function allows you to change brightness of thescreen.Normal ...... Normal brightnessEco............ Lower brightness reduces the lamppower consumption and extends thelamp life.Lamp controlRemote controlLamp life controlThis projector provides two different remote control codes:the factory-set initial code (Code 1) and the secondary code(Code 2). This switching function prevents remote controlinterference when operating several projectors or videoequipment at the same time.When operating the projector in "Code 2", both the projectorand the remote control must be switched to "Code 2".To change the code for the projector:Select either "Code 1" or "Code 2" in this Setting Menu.To change the code for the remote control:Press and hold both the MENU and IMAGE buttonstogether for 5 seconds or more. After changing the code,make sure the remote control operates properly.Lamp controlSelect the lamp operation when the total lighting time of alamp exceeds the recommended total hours of use.Mode 1 .............. The lamp can be turned on even afterexceeding the recommended totalhours of use.Mode 2 .............. The lamp can be turned on even afterexceeding the recommended totalhours of use. But the projector turns offautomatically after 3 minutes.Lamp life control Note:• When different codes are set on the projector and on the remote control, any operation cannot be made. Inthat case, switch the code on the remote control to fit the code on the projector.• If the batteries are removed from the remote control for a long period of time, the remote control code will bereset. Note:• Lamp mode cannot be changed for a while after turningon the projector. Lamp needs some time to stabilizeafter the power is turned on. Stored lamp mode will beactive after the lamp is stabilized.• If Mode 2 has been selected and the projection lampexceeds the recommended total hours of use, thereplacement icon will be displayed at the time of power-on. Then the projector will turn off after 3 minutes.• The Lamp replacement icon will not appear when theDisplay function is set to Off (p.46), during Freeze(p.25), or No show (p.26).Lamp replacement iconSetting
