Sanyo PLC-XR70N Owner's Manual

Also see for PLC-XR70N - 70" Rear Projection TV: Installation manual

15CONNECTING THE PROJECTORCOMPUTER IN 1VIDEO IN 1CONTROL PORT 1AUDIO 1(STEREO)S-VIDEOVIDEO/Y C/Cb(B-Y) Cr(R-Y)COMPUTER IN 2 COMPUTER IN 3 VIDEO IN 3CONTROL PORT 2 CONTROL PORT 3AUDIO 2 AUDIO 3(STEREO) (STEREO)VIDEO/Y C/Cb(B-Y) Cr(R-Y)S-VIDEOL-AUDIO-R(MONO)R-AUDIO-L (MONO)FRONT TERMINALREAR TERMINALVGA CABLE(Supplied)TERMINALMOUSE CABLEFOR ADB PORT(Supplied)AUDIOCABLE(Not Supplied)MAC/VGAADAPTER(Supplied)To COMPUTER IN 1 terminalTo COMPUTER IN 2 terminal To COMPUTER IN 3 terminalTo connect with the Macintosh computer, refer to the figure below.· VGA CABLE (supplied)· VGA/MAC ADAPTER (supplied)· MOUSE CABLE FOR ADB PORT (supplied)· AUDIO CABLE (not supplied)Use Cables and Adapter indicated below.ON2 3 4 5 61ONOFFSet the switches as shown in the table belowdepending on the RESOLUTION MODE that youwant to use before your turn on the projector andcomputer13"MODE (640 x 480)16"MODE (832 x 624)19"MODE (1024 x768)21"MODE (1152 x 870)ONOFFOFF OFF OFF OFFOFF OFFOFFOFF OFF OFFONONON ON ONOFFOFF OFFON ONONON1 2 3 4 5 6MODE SWITCHESuu MAC/VGA ADAPTERConnect to FRONTTERMINAL orREAR TERMINALCONNECTING THE MACINTOSH COMPUTERABTo disconnect MOUSECABLE,1. Hold the portion (B) ofthe connector with onehand.2. Pull the portion (A) to thearrow direction andremove connector.The Switches of theMAC/VGA Adapter