SpecificationsPower Rating . . . . . . . . . . . . . . . . . . . . . . . . 120VAC351W, 4.2A (Max)Antenna Input Impedance . . . . . . . . . . . . . . . . . 75ΩUHF/VHF/CATVDigitalReceiving Channel . . . . . . . . . . . . . . . . 2 - 13 (VHF),14 - 69 (UHF),01, 14-94, 95-125 (CATV)1-99 (Digital)Remote Ready . . . . . . . . . . 32 Key Remote ControlSound Output . . . . . . . . . . . . . . . . . . . . . . 5.0 W/CHIntermediate FrequencyPicture IF Carrier . . . . . . . . . . . . . . . . . . 45.75MHzSound IF Carrier . . . . . . . . . . . . . . . . . . 41.25MHzColor Sub Carrier . . . . . . . . . . . . . . . . . 42.17MHzCabinet DimensionsWidth . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1206mmHeight . . . . . . . . . . . . . . . . . . . . . . . . . . . . 720mmDepth including base . . . . . . . . . . . . . . . . 248mmREFERENCE No. SM780114DP42746, J3TZ, PRODUCT CODE 111009300ContentsSafety Instructions . . . . . . . . . . . . . . . . . . 2Service Adjustments . . . . . . . . . . . . . 3 – 5Power Failure Circuit . . . . . . . . . . . . . . . . 6Mechanical Disassemblies . . . . . . . . 7 – 12Chassis Electrical Parts List . . . . . . 13 – 20Cabinet Parts List . . . . . . . . . . . . . . . . . . 21Component and Test PointLocations . . . . . . . . . . . . . . . . . . . 22 – 24Block Diagrams . . . . . . . . . . . . . . . . 25 – 28Trouble Shooting Flow Charts . . . . 29 – 31Control Port Functions. . . . . . . . . . . 32 – 33Schematic Notes . . . . . . . . . . . . . . . . . . . 34Pin Layouts. . . . . . . . . . . . . . . . . . . . . . . . 35Capacitor and Resistor Codes . . . . . . . . 36Board Connections . . . . . . . . . . . . . 37 – 40Schematic Diagrams . . . . . . . . . . . . 41 – 44ASFILE NO.SERVICE MANUAL Remote Control PlasmaColor Television DP42746 (U.S.A.)(CANADA)ORIGINAL VERSIONChassis No. 42746-00NOTE: Match the Chassis No. onthe unit’s back cover withthe Chassis No. in theService Manual.If the Original VersionService Manual ChassisNo. does not match theunit’s, additional ServiceLiterature is required. Youmust refer to “Notices” to theOriginal Service Manualprior to servicing the unit.ASServicing should be performed by only trained and qualified service personnel.with a double “Z” is a registered trademarkof Sanyo Manufacturing Corporation.© Sanyo Manufacturing Corporation 2006