Sanyo AH-23541 Replacement Procedure

Also see for LNS-W10 - Wide-angle Zoom Lens: Instruction manual Specification sheet Lens Replacement Manual Lens Replacement Manual

Contents

parts list

After the lens replacement (before attaching the top cabinet), check the followingthings.1. Check the lens is properly installed.2. Check no wiring is tangled on the gear of the lens motor or other mechanicalparts.3. Check no parts is missing, or no mounting part is lost.LCD ProjectorLens Replacement ProcedureModel Number1AA6P1P5412-- (IFEK-EI)LNS-T10/LNS-W10/LNS-T11/LNS-W11Lens replacement should be performed by the qualified servicepersonnel.It should be followed by this procedure precisely.Before an attempt to replace the lens, confirm the model number(both the LCD projector and the lens) and prepare the proper lens.Lens installation is different in cabinet design (Type A and B).Before installation the lens, check cabinet design should be made.The lens cover is on the lens for protection. Be sure to remove thelens cover before installation.When installing or removing the lens, be careful not to stain,scratch or damage the lens.If you have any questions, contact the dealers.Notes on Lens ReplacementFollowing parts are contained in the packing. LENS LIGHT-BLOCK SHEET (Spare){Except LNS-W11 (AH-23631)}1 piece1 piece (Part No. 910 322 9677)Notes on Lens ReplacementParts ListPrinted in JapanAH-23541/AH-23511/AH-23661/AH-23631