INSTALLING THE WATER LINEConnecting the water line to the Refrigerator.There are several items that you need to purchase to complete this connection. Youmay find these items sold as a kit at your local hardware store.o 1/4" compression nut ,, copper tubing,, plastic tubing ,, ferrule RefrigeratorCompression nutPlastic tubing @ (1/4") (Supplied) @(Supplied) t(_ Compression fitting(Supplied). ...... ..J_% ..... ,i _ 'i i _ BulbFerru_e:-!--_i :_(Not supplied) i _ :: i _ ',Compression nut (_)(1/4") (Not supplied)Copper tubing or Plastic tubing(Not supplied) (Not supplied)Household water line1. Slip the compression nut @ through the supplied plastic tubing @.2. Tighten the compression nut @ onto the 1/4" compression fitting.- If you are using copper tubing, slip the compression nut _ (not included) and ferrule (not included) oncopper tubing (not included) as shown.- If you are using plastic tubing Q, insert the molded end(Bulb) of the plastic tubing Q into thecompression fitting.CAU'nONZ_DO not use without the molded end(Bulb) of the plastic tubing Q.3. Tighten the compression nut ® onto the compression fitting. Do not over-tighten the compression nut Q.4. Turn water on and check for any leakage.(_ Only connect the water line to a drinkable water source,If you have to repair or disassemble the water line, cut off 1/4" of the plastic tubing to make sure you get a snug,leak-free connection,installing the water filter.1. Remove the water filter cover(l]})2. Remove the fixed cap by turning it counter clockwise.Keep the cap in a safe place for later use if you don'tuse the filter.3. Remove the water filter from the box and put areplacement indicator sticker on the filter as shown.Place a sticker on the filter that dates six months inthe future. For example, if you install the water filter inMarch, put the "SEP" sticker on the filter to remind youto replace in September. That way you'll know whenit is time to replace the filter. Normally, a filter life isabout 6 months.% %Sticker(month indicator)Settiqg Up 17