Samsung P Series User Manual

Also see for PM32F-BC: Quick setup guide User manual User manual Quick setup guide Quick setup guide

65Chapter 5. MenuAutomatic Network Settings (Wired)Connect to the network using a LAN cable.Make sure a LAN cable is connected first.How to set up automatically1 Press the MENU button on the remote control.2 Select Network - Open Network Settings.3 Select Wired.‒ The network test screen appears and then the verification process starts.4 When the connection has been verified, select OK.• If the connection process fails, check the LAN port connection.• If the automatic process cannot find the network connection values or if you want toset the connection manually, go to the next section, network setup.Manual Network Settings (Wired)Offices may use static IP addresses.If this is the case, ask the network administrator for the IP address, subnet mask,gateway and DNS server address. Enter these values manually.Getting the Network Connection ValuesTo view the Network connection values on most Windows computers, follow thesesteps.1 Right click the Network icon on the bottom right of the screen.2 In the pop-up menu that appears, click Status.3 On the dialog that appears, click the Support tab.4 On the Support Tab, click the Details button. The Network connection values aredisplayed.How to set up manually1 Press the MENU button on the remote control.2 Select Network - Open Network Settings.3 Select Wired.‒ The network test screen appears and then the verification process starts.4 Select Stop. The verification process stops.5 Select IP Settings. The IP Settings screen appears.6 Select IP Setting and set it to Enter Manually.‒ Setting IP Setting to Enter Manually automatically changes DNS Setting to EnterManually.7 Enter the network connection values.‒ IP Address, Subnet Mask, Gateway, DNS Server.8 When done, select OK at the bottom of the page, and then press . The networktest screen appears and the verification process starts.9 When the connection has been verified, select OK.