Samsung MIM-E03CN Installation Manual

Also see for MIM-E03CN: Service manual User manual User manual Installation and maintenance manual User manual

6. Remove the front protective film.• When installing a Wired Remote Controller by using a cable longer than 10 m, you must install thecommunication cable and the power cable separately. (Electrical interference can cause the Wired RemoteController to malfunction.)• When installing your Wired Remote Controller on the wall, consider the size of the wire hole, and select a wirewith a proper thickness.• Wire that is connectable to Wired Remote Controller PCB.- If you install the Wired Remote Controller by reclaiming, install it according to U-terminal cable specification.- If you install the Wired Remote Controller by using two pieces of PVC wire, remove the 30 cm of the sheath ofthe cable and install it only with the two pieces of wires. (Recommended specification: AWG20)• The following are the specs of the compression ring terminal connected to your Wired Remote Controller PCB.StudWtEF GLØDRange of Permitted Wires Rated Size Stud Size Basic Size (mm)AWG mm2 mm2 mm t øD G E F W L22 ~ 16 0.25 ~ 1.65 1.5 3 0.7 3.8 10.0 4.5 6.5 6.0 21.2❋ Maximum distance for connecting communication and power cable: 100 m• Screws on the PCB terminal must be tightened with less than 6N-cm tightening torque. If the tightening torqueis greater, it may damage the screw thread.CAUTION9ENGLISH