Samsung HW-Q600A Full Manual

Also see for HW-Q600A: Full manual Full manual Full manual

ENG - 22Disconnecting the Bluetooth device from a SoundbarYou can disconnect a Bluetooth device from the Soundbar. For instructions, see the Bluetooth device’suser manual.• The Soundbar will be disconnected.• When the Soundbar is disconnected from the Bluetooth device, the Soundbar will display“BT DISCONNECTED” on the front display.Disconnecting the Soundbar from the Bluetooth devicePress the (Source) button on the top panel or on the remote control, and then change to any modeexcept “BT”.• Disconnecting takes time because the Bluetooth device must receive a response from theSoundbar. (Disconnection time may differ, depending on the Bluetooth device)• When the Soundbar is disconnected from the Bluetooth device, the Soundbar will display“BT DISCONNECTED” on the front display.NOTES• In Bluetooth connection mode, the Bluetooth connection will be lost if the distance between theSoundbar and the Bluetooth device exceeds 32.8 ft (10 m).• The Soundbar automatically turns off after 20 minutes in the Ready state.More About BluetoothBluetooth is a technology that enables Bluetooth-compliant devices to interconnect easily with eachother using a short wireless connection.• A Bluetooth device may cause noise or malfunction, depending on usage, if:– A part of your body is in contact with the receiving/transmitting system of the Bluetoothdevice or the Soundbar.– It is subject to electrical variation from obstructions caused by a wall, corner, or office partition.– It is exposed to electrical interference from same frequency-band devices including medicalequipment, microwave ovens, and wireless LANs.• Pair the Soundbar with the Bluetooth device while they are close together.• The further the distance between the Soundbar and Bluetooth device, the worse the quality is.If the distance exceeds the Bluetooth operational range, the connection is lost.• In poor reception areas, the Bluetooth connection may not work properly.• The Bluetooth connection only works when it is close to the unit. The connection will beautomatically cut off if the Bluetooth device is out of range. Even within range, the sound qualitymay be degraded by obstacles such as walls or doors.• This wireless device may cause electric interference during its operation.