Samsung HW-Q600A Full Manual

Also see for HW-Q600A: Full manual Full manual Full manual

ENG - iiSAFETY INFORMATIONSAFETY WARNINGSTO REDUCE THE RISK OF ELECTRIC SHOCK, DONOT REMOVE THE COVER (OR BACK).NO USER-SERVICEABLE PARTS ARE INSIDE.REFER SERVICING TO QUALIFIED SERVICEPERSONNEL.Refer to the table below for an explanation ofsymbols which may be on your Samsung product.CAUTIONRISK OF ELECTRIC SHOCK.DO NOT OPEN.This symbol indicates that high voltageis present inside. It is dangerous tomake any kind of contact with anyinternal part of this product.This symbol indicates that this producthas included important literatureconcerning operation and maintenance.Class II product : This symbol indicatesthat it does not require a safetyconnection to electrical earth (ground).If this symbol is not present on aproduct with a power cord, the productMUST have a reliable connection toprotective earth (ground).AC voltage : This symbol indicates thatthe rated voltage marked with thesymbol is AC voltage.DC voltage : This symbol indicates thatthe rated voltage marked with thesymbol is DC voltage.Caution, Consult instructions for use :This symbol instructs the user toconsult the user manual for furthersafety related information.WARNING• To reduce the risk of fire or electric shock, donot expose this appliance to rain or moisture.• To prevent injury, this apparatus must besecurely attached to the floor/wall inaccordance with the installation instructions.CAUTION• Do not expose this apparatus to dripping orsplashing. Do not put objects filled withliquids, such as vases, on the apparatus.• To turn this apparatus off completely, youmust pull the power plug out of the wallsocket. Consequently, the power plug mustbe easily and readily accessible at all times.CAUTION (for Canada)This device contains licence-exempttransmitter(s)/receiver(s) that comply withInnovation, Science and Economic DevelopmentCanada’s licence-exempt RSS(s). Operation issubject to the following two conditions:(1) This device may not cause interference.(2) This device must accept any interference,including interference that may cause undesiredoperation of the device.This device and its antenna(s) must not be co-located or operation in conjunction with any otherantenna or transmitter.This device may automatically discontinuetransmission if there is no information totransmit, or an operational failure. Note that thisis not intended to prohibit the transmission ofcontrol or signaling information or the use ofrepetitive codes where required by thetechnology.This Class B digital apparatus complies withCanadian ICES-003.