Samsung DVD-ROM drive User Manual

Contents

8 9Solving Technical ProblemsSAMSUNG continually strives to improve its products. Both the design specifications andthese user instructions are thus subject to change without notice.Technical SpecificationsProblem Meaning / SolutionThe DVD-ROM drive is notdetected by the computer. Check that the power, audio and IDE cables are correct-ly connected to the computer. Change the IDE cable and reconnect it to the computer.Preferably, connect a second IDE cable to the DVD-ROMdrive in master mode; see page 7 for further details. Check the position of the jumper in the master/slaveselect terminal. Reinstall the device driver or update it with the latestversion by downloading it from the Samsung Web site. This case may occur when there is a Windows instal-lation problem; reinstall Windows. Check whether the audio cable is correctly connectedto the sound output terminal on the DVD-ROM driveand the sound card CD-IN terminal. Check that the sound card is operational. Adjust the volume control. Install the latest version of the device driver. Check whether the CD is of good quality and clean it,if necessary. Check that the power cable is correctly connected. Power off and disconnect the PC. Insert a pin orunfolded paper clip in the emergency hole and pushfirmly until the disc compartment opens. Adjust the size of the replay screen. After checking the display resolution, adjust it, if nec-essary. The computer may not recognize the disc if you startplayback too quickly after inserting the disc.Open and close the disc compartment and try again. Clean the disc and try again. The interface mode of the sound card is AT-BUS.You must therefore connect the DVD-ROM drive tothe IDE port on the PC mother board, rather than tothe sound card, or install an IDE-compatible soundcard.After installing the DVD-ROMdrive, the PC gets slower.The DVD-ROM drive is notrecognized by MS-DOS.The DVD-ROM drive is notdetected by Windows.No sound is heard from anaudio CD.A CD is not read or is readtoo slowly.The disc compartment will notopen.When the MPEG software plays aVideo CD, the pictures are not regu-lar and the running speed is too slow.The Disc is not in message isdisplayed even though a dischas been inserted.The DVD-ROM drive is notdetected after it is connectedto a sound card.Sustained :Max. 13,500KB/sec (10X) /Max. 6,000KB/sec (40X)Sustained :Max. 16,200KB/sec (12X) /Max. 6,000KB/sec (40X)DISCERROR RATEREAR PANELFRONT PANELOPERATINGENVIRONMENTGENERALRELIABILITYDRIVEPERFORMANCEDisc diameterDisc types supportedData transfer rateAccess time(1/3stroke)Data buffer capacityLaserSlide mechanismSpindle motorLoading mechanismEject buttonIndicator(LED)Headphone outputVolume controlDimensionsNet weightOperationStorageRequired powerInterface connectorAudio outputJumper blockMTBFDVD-ROM, DVD-VIDEO, CD-DA(Audio), CD-ROM,CD-ROM XA, CD-Plus, CD-Extra, Photo-CD(Single,Multi-session),Video CD ready, Enhanced CD, CD-I/FMV, CD-R,CD-RW12cm or 8cmPIO Mode 4 : 16.6MB/secMultiword DMA mode 2 : 16.6MB/secUDMA mode 2 : 33MB/sec512KBSemiconductor LaserStepping motorBrushless motorTray. DC motor(Soft Eject). Horizontal/VerticalAuto eject or Auto injectBUSYStereo mini-jack( Ø3.6mm) 0.60±20%(rms) 33ΩWheel knob+5VDC : 2.0A, +12VDC : 1.0A (Max)ATAPILine out 0.70 ± 20%(rms) : 47KΩDevice configuration jumperTemperature : 5 ~ 45°C, Humidity : 8 ~ 80%Temperature : -40 ~ 60°C, Humidity : 5 ~ 90%149(W) x 42(H) x 200(D)mm880g125,000 POH(Duty 20%)10 -15 / MODE1:10 -12, MODE2:10 -9130ms / 110ms(Typical)ITEM SD - 610 SD - 612DVD / CD* In case of the PC without UDMA, it may have a different DVD data transmission rate.

/ 5

Related manuals for Samsung DVD-ROM drive