EnglishEnglish 43MaintenanceEmptying the water tankEmpty the water tank after each use to prevent leaks.A1. Remove the water tank (A) from the dryer.- Pull the water tank handle with one hand untilthe tank is halfway out.- Once the water tank is halfway out, support thebottom of the tank with the other hand and pullit slowly with both hands.CAUTION• The water tank is heavy. Slowly remove the watertank using both hands while keeping the tank at alevel.• Be careful when removing the full water tank. It isvery heavy and can cause injury if you drop it.B2. Empty the water through the drain hole (B), andthen clean inside the water tank.- Mix some neutral detergent in lukewarm water.Fill the water tank with the mixture through thedrain hole (B) and leave it for 30 minutes. Then,rinse the tank with clean water and completelydry it.3. Place the water tank back into place.NOTEIf the dryer displays the “Empty the tank” message and stops while drying is in progress, empty the watertank and tap and hold . The “Empty the tank” message will disappear, and the dryer will resume drying.U-PJT_DRYER_SimpleUX_WEB_SSEC-00_EU_English.indd 43 2021/11/9 17:26:33