Menu
Samsung DV40J3000E(G) SERIES User Manual
Also see for DV40J3000EG Series: User manualUser manual
                                                                                                            |
English - 14InStallatIon - GEnEral procEDurEFor proper installation, we recommend that you hire a qualified installer.Read these instructions completely before you begin the installation.To install the dryer, follow these steps:1. Move your dryer to an appropriate location for installation. Consider installing the dryer and washer side-by-side so you have easy access to both appliances.To move the dryer easily, lay two of the carton cushion-tops on the floor. Tip your dryer on its side so itlies across both cushion-tops. Push the dryer so that it is near its final location. Set your dryer upright.Leave enough room around the dryer so you can attach the duct work, power cord, etc.2. If you need to change the direction of the door, go to Door Reversal on page 19. When done, return toStep 3 below.3. Review the Exhausting section before installing the exhaust system. Install the duct work from yourdryer to the exhaust hood. The crimped end of the duct sections must point away from your dryer. DONOT use sheet metal screws when assembling ducting. These joints should be taped. Never use plasticflexible exhaust material.A tip for tight installations: Attach a section of the exhaust system to your dryer before putting it inplace. Use duct tape to secure this section to your dryer, but do not cover the ventilation slots at theback of the dryer cabinet.4. If you have an electric model, skip to Step 6. If you have a gas model, go to the next step.5. Review the Gas Requirements section, then follow the lettered steps below.a. Remove the pipe thread protective cap.b. Apply pipe joint compound or about 1 1/2 wraps of Teflon tape over all threaded connections.The pipe joint compound must be resistant to the action of any liquefied petroleum gas.c. Connect the gas supply to your dryer. An additional fitting is required to connect the 3/4” (1.9 cm)female thread end of a flexible connector to the 3/8” (1 cm) male threaded end on the dryer.d. Securely tighten the gas line fitting over the threads.e. Turn on the gas supply. Check all gas connections for leaks using a soap solution. If bubblesappear, tighten the connections and recheck. DO NOT use an open flame to check for gas leaks.f. Go to Step 6 on the next pageinstalling your dryer |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved