Samsung DCS 50si User Manual

Also see for DCS 50si: User guide User guide

16When you are transferring a call to a keyset set for Voice Announce or AutoAnswer, the transferred call will always ring.NOTES:1. After the inside party answers, you may alternate back and forth betweenthe parties by pressing the TRSF key.2. If you receive No More Calls tone, that station has no key available to re-ceive another call. Press TRSF to return to the other party.3. You cannot transfer an Intercom call by pressing a DSS key. You must pressthe TRSF key and dial the destination extension number.TRANSFER WITH CAMP-ONWhen you are transferring a call to another station and you receive a busysignal, you may camp the call on to this station. Simply hang up when you hearthe busy signal. The called party will be alerted that a call is waiting for them.NOTE: If you receive No More Calls tone, that station has no key available toreceive another call. Press TRSF to return to the outside caller.TRANSFER TO VOICE MAILThis feature is used to send a call directly to a voice mailbox. Your keyset musthave a correctly programmed VT key to accomplish this. To transfer a call di-rectly to a voice mailbox:• While on a call, press the VT key and dial the mailbox number.• Hang up when dialing is completed.CALL WAITINGIf an outside call has been camped-on to your phone or another station hascamped-on to you:• Your keyset will ring and the call that is waiting for you (camped-on) will flashgreen.• Press the flashing button to answer; your other call will go on hold automati-cally if your station has the Automatic Hold feature set. If not, you mustpress HOLD and then the flashing button.ORFinish the first call and hang up; the waiting call will ring.• Lift the handset or press the ANS/RLS key to answer.NOTE: Intercom calls will not go on Automatic Hold.CONFERENCE CALLSYou may conference up to five parties (you and four others) in any combinationof outside lines and internal stations in any order.• While engaged in a conversation, press the CONF key and receive confer-ence tone.• Make another call, either intercom or outside, press the CONF key andreceive conference tone.• Make another call or press the CONF key to join all parties.• Repeat the last step until all parties are added.NOTE: When attempting to add another party to the conference and you arenot able to reach the desired person, hang up. Simply press the CONF keyagain to return to your previous conversation.To drop a party from your conference call:• Press CONF and dial the extension or line number that is to be dropped.• Press CONF again to reestablish the conference.NOTE: To leave the conference, hang up. Control is passed to the next internalstation. If there are no internal stations and you wish to leave outside linesconnected together in a trunk to trunk conference, press the CONF key plus theCALL button that the call appears on or follow the instructions to drop a partyand use your extension number. When they hang up, the lines will release auto-matically. Press CONF to rejoin a trunk to trunk conference.FORWARDING CALLSYou may forward your calls to another station, group of stations or an externaltelephone number. Program a destination for the type of forwarding you want asdetailed below. If you have FWD ALL, FWD BUSY and FWD NO ANSWERkeys, press one to turn that forward feature on. A steady red light reminds youwhat forward condition is activated.You can clear all call forward conditions set at your station by lifting the handsetand dialing 600.FORWARD ALL CALLSTo forward all your calls under any condition to another station:• Dial 601 plus the extension or group number.• Receive confirmation tone and hang up.NOTES:1. If the Hot Keypad feature has been turned off, you must first lift the handsetor press SPK before you begin dialing.17